Hi Terry,
This is how you set internal/external vref for ADC.
Here is how conversion is done:
Terry Deng said: do we have characteristic curve of Power Up Time vs Temperature on Internal Reference mode?
Unfortunately, we don't have it.
Terry…
Part Number: DLPC3479 Other Parts Discussed in Thread: DLP4710LC , DLPA3005 , DLPC3478 Tool/software: Dear
I am reviewing the industrial scanner using chipset below.
-. (Master) DLPC3478 (Slave) DLPC3478 , DLPA3005 , Beam engine using DLP4710LC 240620_Beam…
Hi Aaron,
Glad to get your message.
Aaron: Could you please advise what mode you are operating in when you see this issue? If you go to the GUI under 'Projector Controls' -> 'Display' -> 'Projection Mode' and perform a 'Get', what is the mode that…
Part Number: TMS320F28388D Tool/software: We bought 3 pieces TMS320F28388D. All of them identical (same hardware revision). When connecting first time to a desktop pc, each board presents different behavior and namely:
the onboard emulator probe appears…
Hi PY,
PYTsai said: We had checked the loopback was enable correctly but no data at CAN0
I'm not sure how you checked that loopback was enabled correctly. Did you read the device registers to verify correct settings? There is also an External and…
Hi Guangyan,
Please find the below responses for your queries:
1. We do not maintain the information regarding hardware pins in our documentation. You may need to refer to the TI Datasheet of the specific target. 2. You can perform parameter tuning…
Hi Joshua,
What do you mean by setting it up for "Monitor and Tune"? Are you trying to make a connection for running TI C2000 MATLAB/Simulink Models in External Mode?
Which device pins are available on your headers?
Best Regards,
Ben Collier
When I load firmware I get this
The same error is received when I try to load directly of CCS. I tried to use TI generic flash linkers but those don’t work at all. Not that this is when I load at external mode. I did not try to deploy though I expect…
Salah,
Can you please clarify your goal? I see some conflict in your description. Here are some use cased based on my understanding:
Generate firmware to run on C2000 device (standalone) --> In this case, you should use the Embedded coder and the…
