Salah,
Can you please clarify your goal? I see some conflict in your description. Here are some use cased based on my understanding:
Generate firmware to run on C2000 device (standalone) --> In this case, you should use the Embedded coder and the…
Hello TI Engineer,
I hope this message finds you well. I wanted to follow up on the investigation progress regarding the issues mentioned earlier. I'm particularly interested in knowing if there are any suggestions or recommendations regarding the configuration…
Part Number: TMS320F280039 Hi team,
Our customer the want to compare the accuracy of ADC between external reference mode and internal reference mode.
They want to check if they can apply a 3.3 Voltage to the REFHI pin when use 1.65V internal reference…
Part Number: DAC80508 Dear Team,
I'm using the DAC with an external 5V reference (REF5050) which is directly connected with REF-Pin of the DAC80508.
When starting up I first power the DAC with 3.3V (VIO) and 5V (VDD). This means that the internal…
Part Number: TMS320F28388D Hi all,
I have a little problem with the eCAPs on the TMS320F28388D.
In the attached picture you can see the desired speed (above) and the actual calculated speed (below). The problem right now is, that the algorithm which…
Hi.
I use CANOE to trace CAN DATA. I have try mcan_loopback_interrupt in "mcu_plus_sdk_am263x_08_02_00_28" only change to external mode and get data well.
I think the PIN isn't a problem.
I also have done build cleaned.
I still cant't figure out…
Dear Matthew,
Thanks for the response. I am the customer with regards to this query.
To answer to your question: Firstly let us consider the Ti Picollo 280049C Launchpad. We have used "External Mode" to read the data in real time while the system…
Tareq,
Please review the attached document (link below). if you are still stuck, you will need to contact MathWorks Technical Support .
---
Troubleshooting Guide: Executing TI C2000 Simulink Models in External Mode
cfs-file/__key/communityserver…
Hi Vijayendra Varma Siddamsetty , I find topic AFE7444EVM: Not able to write AGC register - RF & microwave forum - RF & microwave - TI E2E support forums in which you say that it is impossible.
In this case I like to ask you a question how to configure…
Hi Aaron, I have used DMD on/off, but I found that this operation seems to have no effect on switching modes. I disenable 'autolock config' and updated flash, and found that it was impossible to switch to external mode. So I have to restore flash usage…
