Part Number: BQ76952 Other Parts Discussed in Thread: EV2400 Hi
I have a query need your help.
The chip has programmed OTP, and I use MCU to read the value.
OTP is at the 0x9180 address, Cell 1 Gain writes 12117, and then uses the MCU to read the 0x9180…
Part Number: ADC-WB-BB Hi,
I have purchased two of these converters to measure the insertion loss of twisted pair telephone wire at different length. The result I am getting does not look anything I expect. For my testing I use a network analyzer (a spectrum…
Part Number: AM625
On my computer, make u-boot in sdk installation folder report:
/home/tony/ti-processor-sdk-linux-am62xx-evm-08.06.00.42/board-support/u-boot-2021.01+gitAUTOINC+2ee8efd654-g2ee8efd654/tools/k3_gen_x509_cert.sh -c 16 -b spl/u-boot-spl…
James:
I think the confusion related to Vcm input/output is because the datasheet is using the same term to refer to two different areas. The Vcm pin 24 is an input. This input pin accepts the common mode voltage typically supplied from the ADC. That…
Hello JH,
JH Zhang said: As shown in the figure below, the bq76952 single cell detection accuracy error is very small, while the errors of STACK, PACK and LD reach 0.5V. For detection, the voltage accuracy error of B+ and P+ is larger. Why not use single…
Of course:
Clean:
rich@rich-Precision-3660:~/ti-processor-sdk-linux-j721s2-evm-09_00_00_06/yocto-build/build$ MACHINE=j721s2-evm bitbake tisdk-default-image -c cleanall
NOTE: Started PRServer with DBfile: /home/rich/ti-processor-sdk-linux-j721s2-evm…
Hi Given,
Your understanding with the busbar voltage range of the BQ79616-Q1 is correct. For the BQ79718-Q1 BB voltage range, you are also correct- however, the combined cell and BB voltage need to be within the measurable range of the CB ADC.
Best Regards…
Part Number: SK-AM62 I am following steps mentioned in this link - Overview_Building_the_SDK for building the SDK. I am facing build errors and herewith attached the log of the build. Please let know how to resolve this build error.
8484.log.txt
Part Number: PROCESSOR-SDK-AM62X Hello,
I'm attempting to build the SDK with Yocto per https://software-dl.ti.com/processor-sdk-linux/esd/AM62X/09_01_00_08/exports/docs/linux/Overview_Building_the_SDK.html
Steps:
$ git clone git.ti.com/.../oe-layersetup…
Hi,
I need to design a PCB with SMAs that match the pitch of two female SMAs (differential ends) of ADC-WB-BB as I plan to connect my PCB to ADC-WB-BB board using SMA male-male adaptors, without SMA cables.
Does anyone know the pitch between two female…