Part Number: TI-JESD204-IP Other Parts Discussed in Thread: ADC14X250 Tool/software: Hi,
my project connects a ZCU102 with an ADC14X250 EVM. After configuring the IP to match the ADC features (8b10b, 1 Rx lane, 5 Gbps lane rate, etc.), the next step…
Part Number: ADC12DJ3200EVM Other Parts Discussed in Thread: DAC39RFS10 , DAC39RF10 , ADC14X250 Tool/software: Dear TI Team,
We are planning to use DAC and ADC specifications. Below are the key details:
DAC:
Output Power: Adjustable from -10…
Part Number: ADC14X250EVM Other Parts Discussed in Thread: ADC14X250 Hello,
I am trying to connect the SERDES output of ADC14x250 to SMA.
I am using an evaluation board AD14x250EVM where the SERDES outputs, SO+ and SO- (pins 19 and 20), are routed…
Part Number: 66AK2L06 Other Parts Discussed in Thread: ADC14X250 , , RFSDK , TCI6630K2L Hi,
We try to sample analog signal.
We used RFSDK 2.03. And we succeed to run playback demo properly.
Then, we select 1x1-1xLTE80DEMO2-HC-JESD121121x DFE configuration…
Part Number: ADC14X250EVM Other Parts Discussed in Thread: ADC14X250 Hello, experts.
The user's guide (SLAU625–November 2015) describes that set a clock input signal generator for 250 MHz and use it as the CLK input for ADC14X250, but unfortunately…
Part Number: 66AK2L06 Hi,
We setup the boards by using the Optimized Radar System Design Using 66AK2L06 - DSP+ARM SoC and ADC14X250 .
We were able to sample analog signal in high speed with 66AK2L EVM.
We have achieved IQ Data (We get I and Q data…
I think I understand what you are saying is this:
Since I am using ADC14x250 with TSW14j56, and in HSDC pro I select ADC14X250_LMF_112_LF as my firmware, I should go to this ini file and add the line, am I correct?
But when I do this the syncb over…
Part Number: ADC14X250EVM Other Parts Discussed in Thread: ADC14X250 , TIDEP0060 , RFSDK Hi Team,
My customer is looking at the TIDEP0060 design and connecting the ADC14x250 to the K2L, and has the following questions:
We are trying to understand…
Part Number: 66AK2L06 Other Parts Discussed in Thread: RFSDK , ADC14X250 , , DAC38J84 Hi All,
We want to sample analog signal in high speed with 66AK2L EVM.
We setup the boards by using the Optimized Radar System Design Using 66AK2L06 - DSP+ARM SoC…
Hi John,
I just went through the "Quick Start Guide" in the EVM User's Guide, and was able to get a capture in HSDC Pro using the ADC14X250 EVM Rev B and the TSW14J56 Rev D.
After connecting/powering up all inputs to the boards as described in the…
