Hi Tony,
Unfortunately, we don't have anything available that meets all the requirements, but we do have a few options below:
ADC3541 Parallel CMOS interface but only 14 bit resolution
ADS9813 can run in oversampling mode to have 2 channels running…
Part Number: WAVEVISION5 Other Parts Discussed in Thread: ADC3541 , ADC3563 , ADC3583
Hi Team,
Our customer is looking for an A/D card to read out the DC voltage level (voltage signal from photodiode fed with coaxial cable, photodiode signal will…
Hi Rahul,
what are you using as a clock source? crystal oscillator? Do you have a scope/spectrum analyzer to look at the signals after the buffer?
Please have a look at ADC3543 ( https://www.ti.com/product/ADC3541?keyMatch=ADC3543 ) it's a newer part…
Part Number: ADC3544 Tool/software: Hello, I am attempting to setup DDR parallel 14-bit complex decimated output so that the I and Q components are output on the rising and falling edges respectively as seen in Figure 8-30 of the datasheet. I was able…
Part Number: ADC3543 Other Parts Discussed in Thread: CDCV304 Tool/software: I am bringing up a custom board that uses the ADC3543 data converter. For this application I have elected to go with a single ended clock and I am having difficulties getting…
Hi Y.Ottey,
We are working on getting the link for the PDF up. For now, you can use the attached slides (same as what will be available once link is repaired).
Best Regards,
Dan
New SAR ADC_ ADC35xx_36xx Summary Q1 2021.pdf
Hi Parth,
We are continuing with evm-tda2xxonly, and below is the issue we are facing with McASP.
We took an example AM5748 project for McASP from TI and have done most of the code changes required for McASP to start the operation, but when we’re…
