Part Number: ADS1000 Other Parts Discussed in Thread: ADS7047 Hello, could you help to check if ADS1000 can work with 600Khz input signal? thanks.
Application: VFD/Motor Inverter
Part Number: ADS1000 Other Parts Discussed in Thread: ADS1100 Hello,
Our customer use the ADS1000.
The ADS1000 outputs data with '0011' sign extension sometimes.
ADS1000_sign_extensions.pdf
Could you tell me why it occur?
Best Regards,
Naoki…
Part Number: ADS1000 Hello
Do I have to configure the device PGA gain setting at power up? Or can I change(increase) the gain setting at the time I want to read from the ADC to get better resolution?
I would like to avoid programming the device at…
Part Number: ADS1000-Q1 Hi team,
Could you please help to check if we could use 10nF filter cap on VIN+ in single ended input application?
Also any problem for below SCH?
Hi Praveenkumar, I just read through the ADC1000 datasheet www.ti.com/.../ads1000 and on p. 8 it says that the devices have the address set in the factory to either 1001000 or 1001001, and the packages will be marked accordingly (see p.2 Pin configurations…
Other Parts Discussed in Thread: ADS1000-Q1 Hi There,
My customer is running the ADS1000-Q1 from 2.8V. However the i2c address does not appear to ACK. Other devices running off the bus are operating as expected. The customer is yet to try a bus interrogation…
Other Parts Discussed in Thread: ADS1000 , DRV134 Hi
Can I ask about ASD1000?
Applicaitonis is for GYRO ADC by controller MCU.
1. Circuit Operation:
A. Output voltage(Analog) from GYRO thru ADS1000(ADC communicate with MCU.
(GYRO -> ADC -> MICOM…
Devendra,
You might be able to use the existing ADS1115 driver for the ADS1100 but it would likely take extensive modifications. The two devices may be similar in function, but not similar in operation. The read from and write to the device different…
