Part Number: TSW1418EVM Other Parts Discussed in Thread: ADS4242 , ADC3443 , , TSWDC155EVM Tool/software: Hello,
Is the TSW1418EVM compatible with the ADC3443 or ADS4242 EVMs? If not, what is the best path forward to evaluate the ADC3443 or ADS4242…
Part Number: ADS4242 The datasheet says the ADC can handle a 2 Vpp signal, but in practice the ADC clips and can only handle a 1 Vpp signal. I'm using the ADS4242 EVM board with a signal generator for the input. The input signal is run through an op amp…
Part Number: ADS4242 Hi, I work with ads4242 as a final stage in my rf cascade.
I want to get a low noise figure and therefore try to get
A high gain in low NF such that ADC NF contribution to
Overall NF will be small.
I try to understand if using 1…
Part Number: ADS4242 Ads 4242 has a 2 Vpp analog input condition.
For a 50 ohm input impedance it’s go to PFs of 10 dBm.
It’s true to assume that by using 1:N transformer I can reduce the PFs by factor of N^2 ?
If it’s true, it’s cause also to reduce…
Part Number: ADS4242 Other Parts Discussed in Thread: ADS6442
Hi Team, I would like to see ADS4242 datasheet but I couldn't access product folder now. It is also same with ADS6442.. Could you support it? Best Regards, Yaita
Part Number: ADS4242 Other Parts Discussed in Thread: ADS54J42 , ADS6242 Dear Team,
My customer is considering using our ADS4242 for Dual, 14bit, 60Msps sampling.
As they have a very small FPGA they would like to use only single LVDS lane for each…
Part Number: TMS320C6748
Dear Team,
I found there is no SW driver for upp in latest PDK and I found it in old SW release based on BIOS v5.
I'm afraid it is hard for my customer to develop custom board and attach ADC to upp of C6748 as there is…
Part Number: TMS320C6748 Other Parts Discussed in Thread: ADS4242 , Dear Champs,
Could you please check if ADS4242 can be attached to TMS320C6748 to receive 2ch data with 4 ~ 32MSPS ?
I think upp of C6748 can be used to receive 2ch data from ADS4242…
Other Parts Discussed in Thread: ADS4242 I am using ADS4242 for one of my design. If planning to used CMOS TCXO as clok input to the device. TCXO Voh = 2.97V (90% of 3.3V) and V0l = 0.33V (10% of 3.3V). TCXO output is connected through circuit in fig…
