Other Parts Discussed in Thread: ADS62P29 , ADS62P49 Hello,
I am having issue reading from ADS62P49 registers in SPI mode. I can write to the regs ok. I am following the TI ADS62P49/ADS62P29 Datatsheet page 18. To read from the regs, I set the bit…
hi,chen,
I also want to check the CLKOUTP/M on the ADS62P29 EVM board.
Can I probe that signal without differential probe?
I only have two single ended probe.
thanks.
Alan
Thank you for your reply Jim. Sorry for the delay on my end, as I only have time to work on this project on weekends.
Anyway, the linked files do work. Subbing in the attached .rbf for my generated .rbf causes the ADC to no longer work. So, the only…
hi,Matt,
I am doing some evaluation on TI's ADS62P29 EVM board. Now I am confused about the CLK input ,Can you give some advice?
Datasheet recommends three clk input option.
option 1 is from the external functional generator, however I do not…
Hi,
The data format of the sample data out of the ADS4226 and the ADS62P24 are the same, so for the verilog code for the TSW1200 firmware there is no difference between the two. Both EVMs routed the sample data to the same pairs on the connector that…
Other Parts Discussed in Thread: ADS62P28 Hi,
I have a QAM demodulator consisting of ADS62P28 connected to Spartan-6 FPGA using parallel CMOS signals (FPGA latches data using CLKOUT from ADC).
When sampling incoming signal at 140 MSPS (or lower…
