Part Number: ADS8166 Tool/software: Hi,
I have two pairs of input pins (AIN0 & AIN1, and AIN2 & AIN3), and I would like to use auto-sequence mode.
If I configure the inputs as separate channels (e.g.CH1_CH0_CFG[1:0] = 0), then the measurement is correct…
Part Number: ADS8166 Hello,
I am having trouble reading proper data from the ADS8166. We have configured the module with the following: - External 5 V reference.
- Deactivated the internal reference, refby2 and buffer.
- We are outputting the data…
Part Number: ADS8166 Hello,
I am implementing the ADSB166 in my system and we are having trouble reading data from the registers. So far we are checking that we correctly write to the registers and that we can read it afterwards but for some reason…
Part Number: ADS8166 Hello,
In the datasheet it references a power up time for the device but the heading states ASYNCHRONOUS RESET. Is it true that after every reset even when the power supplies are stable that I have to wait > 10 ms?
I also see…
Part Number: SK-AM62B-P1 Other Parts Discussed in Thread: ADS8166 , SYSCONFIG Tool/software: Dear Team,
I am working on interfacing ADS8166 with M4F.
https://e2e.ti.com/support/data-converters-group/data-converters/f/data-converters-forum/1007339…
Part Number: ADS8166 Hello,
My customer is interested in using ADS8166 with DVDD = 1.8V, however, the device states that it's specified DVDD is from 2.35V to 5.5V (3V typical) even though it's operating DVDD is from 1.65V to 5.5V (3V typical).
Do…
Part Number: ADS8166 Hi Folks,
The ADS8166’s SPI interface can operate @ 70MHz. The period of the clock cycle @ 70 MHz (~14.3 ns) is shorter than the 19ns (max) for the SDO delay (td_CKDO) from rising clock edge. So the delay could be 1-whole clock…
Part Number: ADS8166 Hello,
The td_CKDO of the ADS8166 (19ns maximum) is not compatible with our master SPI that specifies a MISO Data Hold after SCK Rise of 40ns minimum.
Is there a configuration that can remove the early data launch of the ADS8166…
Part Number: ADS8166 Tool/software: We are using the ADS8166 for our design. Per the datasheet, the ADC cycle-time minimum (4us) does not match with the max conversion time (2.5us) plus the min acquisition time (0.3us).
Part Number: ADS8166 Hello ,
We are using the auto sequence feature of the ADS8166 following the steps on page 34 of the datasheet to mimic figure 48. But after we issue the start command our SEQSTS pin never goes high. I see a note in SDO_CNTL4 that…
