Part Number: AM2632 Tool/software: Hi
I went through the below e2e form
AM2632: LP-AM263 SDK : Support plans for Ethernet/IP. - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums
Is it available now?
Part Number: AM2632 Tool/software: Hello：
When debugging the R5_2 core of the AM2632, I encountered a problem:
The debugger automatically disconnected the program after 3~5 minutes of ccs running.
In the debug output, the following information is displayed…
Part Number: AM2632 Tool/software: Hi experts,
My client want to know whether the OS is a must for AM2632 when he use the function of AM2632.
For example, the client want to use ethernet function on AM2632. Does RTOS is a must?
Thanks,
Leo
Part Number: AM2632 Tool/software: Hi,
in customer application, a warm reset is performed using void SOC_generateSwWarmReset(void) after a watchdog interrupt of the ESM. They would like to define their our own cause for the warm reset and output it after…
Hello zx,
z x said: However, I need to configure a single GPIO pin to trigger its own dedicated interrupt instead of sharing a bank-level interrupt. z x said: How should I configure a single GPIO to map to a unique interrupt (instead of a bank)?
Sure this…
Part Number: AM2632 Tool/software: Dear Texas Instruments Support Team,
I hope you are doing well.
We are encountering an issue with the AM2632 CANFD module during development. When sending CAN data without connecting an external CAN analyzer/tool , the…
Part Number: AM2632 Other Parts Discussed in Thread: UNIFLASH Tool/software: I am using uart_uniflash.py to program my board. I can successfully program and power cycle and boot. The problem is, when I tell the script to 'verify' with known different…
Part Number: AM2632 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hi, I want to use a new phy BCM89884 in AM2632 with mido45, but the default phy in sdk is mdio22, how can I add the new phy in syscfg and use mdio45 to contorl phy reg
Part Number: AM2632 Other Parts Discussed in Thread: LP-AM263 , AM2634 , SYSCONFIG Tool/software: Dear TI Technical Support Team,
I am encountering an issue with the ECAP module interrupt not triggering while working on the AM2632 chip nortos. I would…
Hello Stuart,
Please refer below inputs from the expert.
The resonance around 8MHz is a concern as it will introduce a low-frequency ripple on the supply waveform. Any load transients that are at/multiple of this frequency will see elevated impedance…
