Search tips
Showing 689 results View by: Thread Post Sort by

  • AM3356: RAM Corruption

    Part Number: AM3356 Tool/software: Hi Team, I have an inquiry from a customer who is running into intermittent failures on the AM3356: "We are using the AM3356 processor from your company with IAR 8.4 compiler. We are having some issue from the…

  • AM3356: Set GPIO in U-Boot and keep it in Linux

    Part Number: AM3356 Tool/software: I managed to set a GPIO port in U-Boot. But while booting Linux the state is cleared and set again. First approach was by find a way to disable the reset in device tree. Second was was to use "gpio-leds" in device tree…
    • Answered

  • RE: AM3356: RTC access takes a very long time in SDK9.3

    Resolved
    I found that the cause was the 'util-linux-hwclock' . If I change this to "busybox-hwclock", the hwclock command returned immediately, just like in the previous SDK. Thanks. Katusyama

  • AM3356: DDR2 Tuning Tool

    Part Number: AM3356 Tool/software: Hello team, Just like we have a DDR3 tuning tool for AM335x, do we also have a similar tuning tool for DDR2 tuning on AM335x? If not, what is the best option my customer could take? Regards, Shashank

  • AM3356: DDR2 timing parameter calculation

    Part Number: AM3356 Tool/software: Hello Team, Hardware board : Custom board based on beaglebone reference. SoC Used : AM3356 Uboot version : U-Boot SPL 2021.04 Linux kernel version : 5.4.188 SDRAM Used : W972GG6JB-25I SDRAM frequency : 266 MHz …

  • AM3356: part AM3356BZCZD60 test anomaly

    Part Number: AM3356 Tool/software: Hello everyone,I would like to seek your advice regarding a quality issue that has arisen after the installation of the AM3356BZCZD60 component. We have identified several types of quality issues, which we initially…

  • AM3356: Uboot and linux kernel Migration guide

    TI Thinks Resolved
    Part Number: AM3356 Tool/software: Hi Team, Below are details of our board, Hardware board : Custom board based on beaglebone reference. SoC Used : AM3356 Uboot version : U-Boot SPL 2021.04 Linux kernel version : 5.4.188 Build system : GNU Makefile ba…
    • Answered

  • AM3356: RS485 half duplex communication over UART

    Resolved
    Part Number: AM3356 Tool/software: Hi, My customer is asking if UART can be configured with half duplex mode for RS485 communication. ENB signal(Output Enable signal) is required for RS485 and the customer wonders if nRST signal can be used as ENB. Thanks…
    • Resolved

  • RE: AM3356: Cannot enter sleep mode with kernel 6.1.49

    Hi Katsuyama-san, Takeharu Katsuyama said: I don't understand "make linux". In which directory should I run it? I mentioned it in the instruction, "go to the SDK installation directory". The directory has the following content. …

  • AM3356: Support required to boot SPL and U-boot boot from RAM memory

    Part Number: AM3356 Other Parts Discussed in Thread: SEGGER Tool/software: Hardware board : Custom board based on beaglebone reference. Tool used to copy u-boot and SPL into internal RAM : Jlink segger Boot mode configured : NAND boot (SD card not supported…

Didn't find what you are looking for? Post a new question.