Due to the U.S. Thanksgiving holiday, please expect delayed responses during the week of 11/22.



Search tips
Showing 496 results View by: Thread Post Sort by

  • AM3505: Internal pull-up/down register value

    TI Thinks Resolved
    Part Number: AM3505 Hi Team, The customer is using AM3505AZER with PHY and wants to know the internal pull-up/down register value which is including the variation Would you please provide it? There is II : Input current for dual voltage IO pins specification…
    • Answered

  • AM3505: Backwards Compatibility with eMMC standards later than v4.2

    Resolved
    Part Number: AM3505 Hello. Section 24.4.7.6 of the TRM states that it supports MMC Specification v4.2. Can you confirm if we can use later versions of this MMC specification with the AM3505? Thanks.
    • Resolved

  • AM3505: eMMC goes into INACTIVE state

    Part Number: AM3505 Hi All Are there any known cases of the eMMC chip to go into INACTIVE state We are using AM3505 and eMMC from different vendors, in some units it looks like the eMMC has changed state into INACTIVE mode after have being initialized…

  • AM3505: Flickering Splash Screen

    TI Thinks Resolved
    Part Number: AM3505 Hello Everyone, So I've been having this problem for a while now and I'm finally coming to the forums for help after pulling my hair out lol. I am using VAR_SOM_AM3505 WINCE6. Everything is working fine for 800x600 resolution…
    • Answered

  • CCS/AM3505: Kernal Patch Inquiry

    Resolved
    Part Number: AM3505 Tool/software: Code Composer Studio Hello team, I have a customer working with the AM35xx device family for a Beagle Bone Board - like - project. The contact is a software engineer inquiring about official code from TI regarding a…
    • Resolved
    • Answered

  • RE: AM3505: ASIC ID on UART3 is incomplete - only a few bytes transmitted

    Resolved
    OK, i wasn't expecting that since the previous board was working. The pull down resistor on your board most likely is in conflict with an internal pull up that is configured by the ROM. The internal pull value can vary from part to part, and thus…

  • AM3505: Internal reset sources

    TI Thinks Resolved
    Part Number: AM3505 From the 24.2.2.3 of AM35X TRM( http://www.ti.com/lit/ug/sprugr0c/sprugr0c.pdf ) , I saw the ‘ sys_nreswarm’ signal will be triggered by ‘internal reset’. I'm wondering what does the ‘internal reset’ mean, what…

  • AM3505: ARM debug registers access

    Part Number: AM3505 Customer is trying to debug a very intermittent problem on a product that uses the AM3505. They are trying to use the ARM debug features by programmatically configure a watchpoint. They have found where the ARM debug registers are…

  • AM3505: Recommended PMIC

    TI Thinks Resolved
    Part Number: AM3505 I wanted to use your design resource to find all recommended PMICs that support the AM3505 Sitara Processor - using the following url: http://www.ti.com/design-resources/design-tools-simulation/processor-fpga-power/texas-instruments…

  • AM3505: Which source can make sys_nreswarm get low.

    TI Thinks Resolved
    Part Number: AM3505 Hi all, Customer find sometimes the sys_nreswarm of am3505 will get low. The TRM said internal reset will cause the sys_nreswarm get low.They want to know which source will cause this happen? Could you please help this? thanks! BR, D…

Didn't find what you are looking for? Post a new question.