Part Number: AM5718-HIREL Other Parts Discussed in Thread: AM5718
Hello,
we observes Sitara lock down issues from time to time (very low occurrence): Linux never finishes the boot sequence and seems to loop endless during UART3 initialization.
Project…
Part Number: AM5718-HIREL Hello,
I asked a more generic question of TI support (see below) but didn't quite get the answers I was hoping for. However, one of the options suggested in the listing of processors considered military grade was AM5718-HIREL…
Part Number: AM5718-HIREL Hi, everyone
I have a question about the relationship between OPP voltage and frequency described in section 5.5.2 of the data sheet (SPRS999).
We plan to run MPU_CLK at 600MHz. In this case, is it okay to decrease the VD_MPU…
Part Number: AM5718-HIREL Other Parts Discussed in Thread: AM5718 Hello Expert,
Our customer asked to provide the detail difference information between AM5718AABCXQ1 and AM5718AABCXA (Extended Temp.),
especially, packaage , assembly and testing differences…
Part Number: AM5718-HIREL Hi Support Team,
I'd like to use QSPI of AM5718-hirel as master mode. In this case, what is the Period jitter of QSPI clock output(qspi1_sclk)? I could not find the description in the datasheet.
Best Regards,
Part Number: AM5718-HIREL Other Parts Discussed in Thread: AM5718 Hi, everyone
I have a question about QSPI of AM5718-HIREL.
In Table 7-43 of AM5718-HIREL datasheet(SPRS999), td(SCLK-D0) is -1.6 to 2.6 ns. However, in AM5718 datasheet(SPRS957I), td(SCLK…
Hi Jay,
Jay Vivarekar said: However, when I increase the size of the transaction at runtime, the slave does not receive all the data, rather lesser than the transaction count. More suprsisingly, the slave again starts receiving all of the data when I re…
Hi Jiming,
Please refer to the similar discussion in the thread https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1106028/tda4vm-tda4vm-gpio1_26-interrupt-is-triggered-only-after-gpio1_2-interrupt-is-triggered and see if that helps…
Part Number: AM5718-HIREL Other Parts Discussed in Thread: AM3358 Hello,
We are looking for a processor to be used in a battery-powered, connected device. We would like to start a discussion on what could be a good choice for us. I have selected AM5718…
Part Number: AM5718-HIREL Other Parts Discussed in Thread: AM5718
Hi,
Can you confirm that the MAC address of each AM5718 GMAC interface (GMAC_SW port 0 and GMAC_SW port 1) are factory configured with a unique value (Factory setting of eFuse registers…
