Novica,
On your hardware, one suspect is that some of your boot code tried to write efused subsystems on AM6526 device. Since you original software was development on the superset device, there might be some unintentional writes to some subsystem or config…
Part Number: AM6526 Hi,
I have two SD cards with this partition table
Device Boot Start End Sectors Size Id Type /dev/mmcblk0p1 * 8192 212991 204800 100M c W95 FAT32 (LBA) /dev/mmcblk0p2 212992 278527 65536 32M c W95 FAT32 (LBA) /dev/mmcblk0p3 …
Part Number: AM6526
Hi Expert.
I want to get schematic review from experts.
I attach schematic about SYSBOOT and 1G DDR4 Interfaces
I copied almost drawing from evaluation board as possible as I can.
But I am worrying my mistakes
I am a little confused…
Hi Brad,
Thanks.
B.C. said: The *_EP_* register should be used in endpoint mode.
In this case, then should the PCIE_RC_GEN2_CTRL_OFF register be used for the receiving side signals?
Best regards,
Mari
Mari,
DDR50 is an operational mode that can be operated at frequency up to 50 MHz. Although the maximum 50 MHz is not supported on AM6526, the operational mode is still supported, with frequency limited to 40 MHz, as currently shown in the data manual…
Part Number: AM6526 Other Parts Discussed in Thread: AM2434
edit: typos
Dear sirs,
we're a company that manufactures high end COBOTs, both the mechanical and the electric/electronic parts.
In the following, I describe the project we're involved in…
Part Number: AM6526 Hi:
I want to know if PTP and HSR/PRP is supported on SDK Linux for AM65X 08_01_00?I only find these feature on AM3X and Am5X
Thanks
GukHyun Lee said: 1. am65x really needs to have ECC memory mandatorily?
2. I want to put only 1GB or 2GB Memory without ecc memory, not like IDK Board. Is it possible?
3. When I made a board whose memory is under 4GB, How can I let the SOC know the memory…