Part Number: AMIC120 Other Parts Discussed in Thread: SYSCONFIG Dear Ladies and Gentleman,
I have a problem with PIN MUX Tool Version: 4.0.1543 and the AMIC120.
The EMAC Interface for a single Port MII1 or RGMII1 is there not available,
although the pins…
Part Number: AMIC120 I am using AMIC120 SITARA processor in my project as a processor. MMC0 port is using as SD card interface. n24 pin from the AMIC120 processor is using as SD card detect pin.
when no SD card is inserted, detect signal is LOW. when…
Part Number: AMIC120 Hello,
I am running Biss-C project with my encoder and it works well.
I would like to access encoder's register and clear the multi-turn counter.
A part of encoder's specification is following.
Can we do it with Biss-C interface…
Part Number: AMIC120 Hi Experts, Is it possible to implement both EnDat2.2 and EtherCAT Slave with AMIC120. Thank you for your check. Best regards, Hitoshi
Part Number: AMIC120
Hi,
I have a few questions from a customer.
One question that is key to the application is whether a single PRU with dual cores can support two HSR/PRP enabled Ethernet ports? This would mean that we could, for example, on the…
Part Number: AMIC120
interested in the use of the PRUs in terms of the HSR/PRP functionality that they offer. One question that is key to the application is whether a single PRU with dual cores can support two HSR/PRP enabled Ethernet ports? This would…
Part Number: AMIC120 Other Parts Discussed in Thread: PROFIBUS , AMIC110 , Hi Sir:
I find that about the profinet,and profibus。get form TI is limited?. So if i want to use the AMIC110 and AMIC120, I also need to get i license.
Part Number: AMIC120
I am using pinmux tool to make the pin mapping in the AMIC120 processor, I want to confirm that, will it be ok if we set the SYSBOOT pins to GPIO in the Pinmux file??
Thanks and regards
ARVINDA
Part Number: AMIC120
I am using AMIC120 GPMC memory bus to access external memory designed in the FPGA. I want to know that how to select the particular chip select, for example i am using CS3 in my design and i want to configure the CS3 to my design…