Part Number: BQ24038 Dear all,
Do you have the recommended length from BAT pin to battery?
I think that there is no recommendation because of voltage drop and battery specification.
Best regards,
Part Number: BQ24038 Dear all,
Could you teach us K(SET) parameter at Io(BAT) > 1.0A?
I would like to use this device as Io(BAT) = 1.5A, but I cannot figure equation (5) because I don't know K(SET).
Best regards,
Part Number: BQ24038 Dear all,
Are there the recommended timing when we should change VBSEL setting?
Or are there the non-recommended timing when we should change VBSEL setting?
For example, must not we change during battery charging?
Best…
Part Number: BQ24038 Other Parts Discussed in Thread: BQ24032A Dear all,
Could you teach about the setting of ISET2 pin at AC Mode?
I use this device as PSEL=Hi and Iout =1.5A by ISET1 setting.
However, I do not understand about 10.4.4.2 terms…
Part Number: BQ24038 Other Parts Discussed in Thread: BQ25606 Hello
Please see attached file.
My customer is designing the battery charger cradle and ask us to sggest the lowest chager IC.
please tell us any advice which Charger IC sould I suggest…
Other Parts Discussed in Thread: BQ24038 Does the BQ24038 have a battery cut off feature that disconnects the load from the Li-Ion battery when/if the battery voltage drops below a level (i.e. 2.7V) that woudl cause damage in the cell? I saw no mention…
Other Parts Discussed in Thread: BQ24038 , TPS65950 We are looking for a Linux driver for controller a battery charger IC (BQ24038). We need to control the charger from a Linux app on an OMAP device, and we would like to have a starting point for the…
Other Parts Discussed in Thread: BQ27510-G2 Hi, I am intersting in a battery fuel gauge to control the rate of charge/ discharge of the battery of my system.
Would it be a good option use BQ27510-G2 battery fuel gauge ?
My battery is a ion…
