Part Number: BQ24392 Tool/software: Hi,
We want to use BQ24392 IC to enable the USB2.0 signal only when the valid VBUS source is connected to the external contacts.
Please see the attached block diagram, which explains the configuration details. …
Part Number: BQ24392
Hi team,
I have a question how BQ24392 reacts when the source is in "suspend" mode.
In suspend mode, the device is only allowed to draw less than 2.5mA.
Source: https://www.usb.org/document-library/battery-charging-v12…
Part Number: BQ24392 Other Parts Discussed in Thread: TPS2001E , TUSB320 , BQ24070 Tool/software: Hello TI E2E support team,
Currently we are using a BQ24392 USB2.0 High speed dataline switch for micro-USB port interface. We are planning to change existing…
Part Number: BQ24392-Q1
Hi,
I would like to confirm the feasibility of combining TPS25751S with BQ24392-Q1 in the following USB system configuration.
Our system requirements are:
• The printer (our product) must operate as a USB Host (DFP) and…
Part Number: BQ24392 Tool/software: We're using a BQ24392 to support USB BCS 1.2 for A to C adapters and a separate chip for USB-C to support 5V / 3A (CC line interrogation).
This device requires Dual Role support.
It must be able to hook to a host…
Part Number: BQ24392
Tool/software:
hi team,
When the BQ24392 is powered off, will it be a problem if a voltage of about 0.6V is applied to the CHG_DET pin?
Regards,
Shoo
Part Number: BQ24392 Other Parts Discussed in Thread: BQ25629
Tool/software:
Hi team,
Do you have any way to pass BC1.2 USB compliance test with BQ24392?
https://e2e.ti.com/support/interface-group/interface/f/interface-forum/742181/bq24392-fail…
Part Number: TPS2547 Other Parts Discussed in Thread: BQ24392 , TPS2546 , Tool/software: Hi team,
BQ24392, BC1.2 detector cannot pass BC1.2 compliance test.
TPS2547 or TPS2546 can replace BQ24392? and these device can pass BC1.2 compliance test…
Part Number: BQ24392 Hi Team,
Could you share with me more info regarding to the typical application? our datasheet says it can enable & disable the data path and detect the chargers. Then how we turn on and off the internal switch? by detect the charger…
Part Number: BQ24392 Dear TI Expert,
My customer failed to pass BC1.2 test about D+ / D- voltage, below is the schematics, test result, could you kindly help to give some advice? Thanks a lot.
Failure brief:
No. 6 in the test log : D- measurement…
