Hi Adam,
Thank you for describing the problem clearly.
You are using CAPTIVATE-PGMR to connect Hardware Board with the USS GUI.
We are not sure whether it(CAPTIVATE-PGMR) can be used.
Do you have an EVM430-FR6047 or EVM430-FR6043 board? You…
Part Number: MSP430FR2675 Other Parts Discussed in Thread: CAPTIVATE-PGMR , BOOSTXL-CAPKEYPAD , CAPTIVATE-FR2676
Captivate Design Center doesn't seem to be interacting with my target (proprietary hardware). There are no errors displayed, and I don't…
Part Number: CAPTIVATE-FR2676 Other Parts Discussed in Thread: CAPTIVATE-PGMR , , CAPTIVATE-BSWP , MSP430F5528 , MSP430FR2676 Hi, I have the captivate-fr2676 development kit including the captivate-pgmr and the captivate-bswp and was hoping for the 'out…
Hi, Anh,
CAPTIVATE-PGMR has eZ-FET integrated. So Uniflash should support it.
I tried to program MSP430FR2633 with the CAPTIVATE-PGMR with Uniflash v6.0.02710 but failed. The auto-detection is failed and error message is same as yours.
Then I installed…
Part Number: MSP430FR2676 Other Parts Discussed in Thread: CAPTIVATE-PGMR Hi everyone, I have a problem when using delay loop on MSPFR2676. When I use a delay approxiamtly < 1500 ms, it runs okay. Otherwise, it will crash when runs to delay in while(1…
Part Number: MSP430FR2512 Other Parts Discussed in Thread: CAPTIVATE-PGMR I just wanted to verify I am setting the RST connection up correctly on the MSP430FR2512.
I intend to use the CAPTIVATE-PGMR to program this board and have followed the guides…
Hi Dave,
Sounds good. Keep me advised.
I want to also clarify that the HID bridge on the CAPTIVATE-PGMR only to supports an I2C/UART interface between the MSP430FR2676 and the Captivate Design Center GUI. It cannot be used as a general purpose UART…
Hi,
This is need USB HID, I think is not the COMx.
I don't have your board, but I know the CapTIvate board, If I don't connect the CAPTIVATE-PGMR board or a bad CAPTIVATE-PGMR board, the similar issue will occur.
When the normal USB HID connected…
Part Number: MSP430FR2676 Other Parts Discussed in Thread: CAPTIVATE-FR2676 , CAPTIVATE-PGMR Hello All,
I want to interface an I2C based sensor with MSP430FR2676 where i have connected I2C sensor to Pin P4.3 and P4.4.
For this i am using Captivate…
Hi,
You need below package:
CAPTIVATE-PGMR //Programmer/debugger for captivate mcu
CAPTIVATE-FR2676 // MCU board
CAPTIVATE-BSWP or others. // touch board.
