Part Number: CC1120 Other Parts Discussed in Thread: CC1101 , , WMBUS Dear TI Teams,
We have noticed from the product introduction page of TI's official website that CC1120 and CC1101 support the wireless M-bus protocol. But as we know, both of them are…
Hi Fabio,
There is a possibility that their board has been damaged since they should be seeing a greater output power.
Do they have several boards to test ?
I would repeat the previous test and measure at the CC112x_RF position with the SAW filter removed…
Part Number: CC1120 When sending, one of the following errors occurs and the message cannot be sent.
Please tell me the cause and countermeasures.
(1)PLL SETTLING timeout After sending the STX command strobe, the Status Byte STATE[2:0] does not cha…
hi Diego P ,
Sorry for the delay in posting the reply.
Diego P said: Have you verified with a spectrum analyzer that the Tx device is transmitting at the configured frequency, 868 MHz based on your register settings?
We don't have Spectrum analyser with us…
Part Number: CC1120 Hi team,
May I know how long does RESET_N pin hold logic low to activate the reset of CC1120? My customer would like to manually reset the IC, but I wasn't able to find the duration of logic low on RESET_N pin.
Best regards,
Shunsuke…
Part Number: CC1120 I'm currently using the CC1120 as a transceiver in FIFO mode, operating on 2FSK with a frequency of 433MHz. I don't require the built-in packet handling features like CRC, FEC, and Data Whitening. This is because my data processing…
Part Number: CC1120 Other Parts Discussed in Thread: CC1125 , Hello
We are using CC1125 for 12,5kHz narrow band application at 869,212MHz (Social Care under EN300-220), and using a 38,4MHz TCXO clock.
Supply voltage= 3,3V
Have found that CC1120 is nearly…
Part Number: CC1120 Hi TI team:
I am using CC1120 as a transceiver, and the configuration used is also recommended by smartRF studio. The frequency I use is 433MHz. 4FSK, FIFO mode, symbol rate is 9600bps, deviation is set to 4.8KHz. RX filter BW is 40KHz…
Part Number: CC1120 Hello,
We are substituting a CC1120 into a legacy design operating in MSK modulation at 9.6ksps, 20kHz bandwidth and 2.4KHz deviation. The transmitted data is in the form of UART style bytes with start and stop bits. The link with…
Part Number: CC1120 Other Parts Discussed in Thread: CC1101 Hi,
just by accident I found CC1101 value line supports FEC/Interleaving. A lot of other TI chips do either.
Why performance line CC112x don't?
Yes, I know DN504 and the price tag of FEC,…