Part Number: CC2510 Hi,
I use the Vector Signal Analysis of keysight----89600 VSA ,a software can analysis the signal form CC2510.The software can demodulation the different modulation signals and show the data and constellation.When I set the 2FSK mode…
Part Number: CC2510 Hello,
We have some questions about the CC2510 input port’s dynamic behavior (there is basically nothing in the datasheet).
BTW, this is one of the ordinary PIOs, specifically PIO1_2, not one of the two special PIOs, PIO1_0 and…
Part Number: CC2510 Hello,
I am using LIS2DE12 motion sensor with CC2510 over SPI communication. The logic is "on motion detection, enable TX/RX of CC2510". The module worked well for 3 to 4 days but post that it stopped communication with the sensor…
Part Number: CC2510 Dear Siri (or any other EE),
I would greatly appreciate your help with this problem:
After successful DMA transfer from memory to USART0 TX, it is no more possible to use read MOSI response from a Slave device. Although I can see a…
Part Number: CC2510 Hello,
For one of the application, I want to put CC2510 in PM2 mode accurately for 10 msec, 1500 msec & 4990 msec. But I am not able to accurately obtain the sleep timing. For 10 msec, sometimes it comes as 4.69 msec, 8.68 msec. Below…
Part Number: CC2510 Other Parts Discussed in Thread: SIMPLELINK-2-4GHZ-DESIGN-REVIEWS Hi,
We are using CC2510 as a transmitter for wireless sensors. It has been observed that the board resets. It worked fine for a couple of days after that it starts resetting…
Part Number: CC2510 Other Parts Discussed in Thread: CC-DEBUGGER , Problem Description:
After preliminary analysis, we have confirmed that the TX port of the module component did not send data to the main control board, but the module worked normally
…
Part Number: CC2510 Hello,
I want to measure the time correctly from the start of the code to the current time. I was thinking of using Timer 1. But the device is also using PM2 mode. Is it possible to use timer 1 without disturbing the device sleep timer…
Part Number: CC2510 Other Parts Discussed in Thread: CC2592 , Hello,
I have connected a piezo-electric buzzer to P1_0 of CC2510. It also has a CC2592 range extender. It is operated with a square wave with 50% duty cycle & 1 Hz frequency. The current consumption…
Part Number: CC2510-CC2511DK Hi
I have just bought the evaluation kit containing the CC2511DK dongle. I have installed the SmartRF Packet Sniffer 2 software but my computer does not recognise the device. I tried to install the drivers on the CD sold with…