Part Number: CD74HC4051-Q1 Hi expert,
Since there is -24 voltage in the system, in order to avoid over-voltage damage to Ax to Gnd, can the maximum current be limited to avoid negative voltage damage to the Device? What should be the maximum limiting…
Part Number: CD74HC4051-Q1 Hi team,
I have an application question which need your help.
After the chip is powered on, what is the state of S0 S1 and S2? Does X mean high impedance? And if not, what would it be?
If the GPIO pin of C2000, which connected…
Part Number: CD74HC4051-Q1 Hi team,
How to understand the "Operation Control Voltage" and "Switch Voltage" in datasheet?
As far as I understand, "Switch Voltage = 0 V to 10 V" means the max analog signal swing through Channel I/O pin…
Part Number: CD74HC4051-Q1 Hello Team,
Can CD74HC4051-Q1 replace 74HC4851PW-Q100? The nexperia part pin 7 is NC where the VEE pin of the TI part is dedicated.
What is the function of VEE pin?
Thanks in advance.
Joern
Part Number: CD74HC4051-Q1 Hi,
A customer is evaluating the CD74HC4051-Q1 and has a couple of questions below:
- What would be the propagation delay at Vcc=3.3V and Vee=GND?
- How is the jitter performance?
- There are also concerns over typical and max…
Part Number: CD74HC4051 Other Parts Discussed in Thread: CD74HCT4067-Q1 Dear Team
The current project requires the use of an analog switch similar to the function of the CD74HC4051, whether there are more channels than the CD74HC4051 chip model please…
Part Number: CD74HC4051-Q1 E2E,
What’s the max input voltage of CHANNEL I/O AX?
If the input voltage of channel 1 is higher than absolute maximum ratings, does it affect other channel?
If any diagram could help customer analyze this failure? …
Other Parts Discussed in Thread: CD74HC4051-Q1 , CD4051B-Q1 , MUX508 If Vcc is connected to + 12V, Vee is connected to -12v, because there are 8 channels, 8 channel input analog signals can be between positive and negative 12V?
Part Number: CD74HC4051-Q1 team
I recommended to connect the unused input pins among A0 ~ A7 pins to GND.
BTW,, may I ask why we has to connect the unused input pins among A0 ~ A7 pins to VCC or GND ?
Part Number: CD74HC4051-Q1 Other Parts Discussed in Thread: CD74HCT4051-Q1 Hi Team
may I get your reply on the below ?
thanks.
[Q1] CD74HC4051-Q1 can bi-directional transfer analog signal in the range of ± 6V by VCC ~ VEE pins by setting VCC = +6V and…