Part Number: CD74HCT4067-Q1 Other Parts Discussed in Thread: CD4051B-Q1 , CD74HC4067 Hi,
Due to system constraints I need to use CD74HCT4067QM96Q1 with Vcc=5.7V.
Can you please advise what are the possible implications?
Thanks
Part Number: CD74HC4067 Hi guys,
are there protection diodes inside that CMOS devices? Which max. current are they capable if there are some?
The question is if I need external protection diodes due to over voltage above 5.5V.
Thanks,
Mar…
Part Number: CD74HCT4067-Q1 Hi team,
Could you help me calculating the total leakage current in following condition?
Using all 16ch
E=5V
VCC=5V
Best regards,
Kurumi
Part Number: CD74HCT4067 74HCT4067M 5.1V powerd；When the input voltage on channel Ix is greater than 4.3V，Select other channels will read 500mV voltage（Increased with Ix input） on pin1（in fact other channels are float）；Is this phenomenon normal?How can…
Part Number: CD74HCT4067-Q1 Dear, Sir.
My customer is considering CD74HCT4067-Q1 as the Demux function.
They are asking the data latch(data holding) will be performed on each output,
i0 to i15.
I believe the schematic on the datasheet will be…
Part Number: CD74HCT4067 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hello Team,
I have a customer that is requesting a spice model for the CD74HCT4067, however I do not see one available.
Is there an equivalent…
Other Parts Discussed in Thread: CD74HCT4067 , LMV324 I am working on a design which uses the CD74HCT4067 to switch 16 high impedance sources (~2K ohms) to the input of an ADC.
Whenever the source switches I see what looks like charge injection back…
Other Parts Discussed in Thread: CD74HCT4067-Q1 Hi,
I want to know two things about this IC:
1. is it ok to connect VCC to 5V and S0-S3 to signals at 3.3V?
2. Is it ok to drive a solenoid of 62ohm & 5V rating through this device where i/p is connected…
Other Parts Discussed in Thread: ULN2003V12 , CD74HCT4067 , DRV8860 , TIDA-00117 Hi,
I need to drive a relay coil rated 12V DC coil voltage, 720 ohm coil resistance and 200mW switching power. Instead of using a driver for each and every relay, I want…
