There is a problem with using BSL Scripter with generic USB-to-UART adapters like your FT232 or my CP2102. And that is that Scripter does not generate the hardware invocation sequence on DTR and RTS. Surprise!!! Instead, it depends on a TI officially…
Cristian, I'm afraid I have given you bad advice. I originally tested INVOKE with the CP2102 adapter, and was successful programming an FR2311. But at the time I did not have either FT232 or CH340 adapters to test. I assumed the generic adapters and their…
Part Number: CC1310 Hello,
i have the E70-868T14S module and i want to ask if it can be programming via uart??
I don't have any development kit of texas instrument (cc1310 launchpad...) only a few usb to uart bridge(cp2102,ch340), It can be programmed…
Hi Saurabh, 1) Yes the COM port number is correct. Only one USB to UART convertor is connected to the laptop. 2) It is just a copy of the firmware and Windows has appended (2) to it. Verified whether the same firmware is present on the glogger and Linux…
Other Parts Discussed in Thread: MSP430F5438 , MSP430F5418 , MSP430F5435 , MSP430F5437 Hi everyone, constantly we are getting an error while trying to initialize MSP430F5438 via cp2102. we are using bsl_scripter for initialization of msp430. Connected…
Part Number: CC1101 Hey, I'm new in RF design and would like to make a pcb with CC1101. I use esp32 micro controller and cp2102 in UART communication. All passive components are in 0402 packages, RF chip is connected via lines with 0.254 mm width, and…
The older MSP430F1, F2, F4 and G2 devices with embedded BSL are flashed with BSLDEMO.exe. The new version of that program contained in the DEPRECATED folder of BSL-Scripter v3.4.0.2, with files dated 9/26/19, now supports the use of generic USB adapters…
Hi Devin,
Thank you for the reply.
I have used TTL UART module (see link below) for SCI communication and its working. I am able to see the characters i sent on the communication port.
https://www.indiamart.com/proddetail/cp2102-usb-2-0-to-ttl-uart…
Ok can`t tell why but now it is working.
I tested it with the CP2102, problem persists.
Tried the XDS110 again, now is working.
Tried again the CP2102, now here is working too.
The application I`m making right now uses a lot of UART transmission…
HI Rajaravi krishna,
As you told that it was loaded successfully,when i run the following in command line C:\ti\c2000\C2000Ware_1_00_04_00\utilities\flash_programmers\serial flash programmer serial flash programmer.exe -d f2803x -k f28335 flash kernel…
