Part Number: AM623 Other Parts Discussed in Thread: DAC6311 Tool/software: Hi Team,
I am currently working with the DAC6311IDCKR connected to the SPI1 bus on our custom board. We have configured the device tree with the following pinmux for the SPI1 interface…
Part Number: DAC6311 About DACx311Series Device, do they have P/U resistors or P/D resistors each inside?
Three terminals are follows. If exists, how many kΩ are there?
And also do they have diode of ESD protection?
a)SYNC/
b)SCLK
c)Din
Thank…
Part Number: DAC6311 About DACx311, please tell us the operating moisture range?
Could it apply 5~95% OK? If no, please show the spec value (?% ~ ?%).
Thank you.
Part Number: DAC6311 Hello,
Is there additional data about the output leakage in High-Z configuration (POWER-DOWN MODE bits PD[1]=PD[0]=1) over temperature?
Not found in https://www.ti.com/lit/gpn/dac6311
Thanks!
Part Number: CC430F5137 Other Parts Discussed in Thread: DAC6311 , DAC161S997 , Tool/software: Code Composer Studio Hi,
For using 0-10v output, I try to using dac6311 by I2C interface.
I found datasheet about dac6311.
But, I don't understand this.
…
Other Parts Discussed in Thread: DAC6311 [ DAC6311 ] Serial Interface with Open Drain output
Adding information with red. Correction with valid description in blue
Hi, My customer has evaluated DAC6311 connecting with open drain interface with 10kohm pull…
Other Parts Discussed in Thread: DAC6311 , DAC7551 , DAC161S055 , DAC8551 , DAC101S101 , DAC121S101 , DAC7512 , DAC8531 , DAC8501 , DAC8560 , DAC8881 Do we have a DAC ( SPEC is similar as DAC6311) with a less than 1mm height ?
Other Parts Discussed in Thread: DAC6311 Hi,
There are the undershoot about 300~360mV at the /SYNC, SCLK, DIN pins as attached image. Question 1 . IN the datasheet, there are the absolute maximum ratings as "-0.3V to +AVdd + 0.3V " for DC voltage.…
Other Parts Discussed in Thread: DAC6311 PCN# 20130514000 - DAC6311 The AVDD has been revised from 1.8 to 2V.
What prompted this change? What parameters are affected if the "new" part is driven at 1.8V?
Other Parts Discussed in Thread: DAC7311 , OPA353 Using the DAC7311 EVM and an external reference on J2 pin 20 I noticed that the voltage going to the DAC7311 was much lower than the input reference voltage.
The cause of the discrepancy was the R2 which…