Part Number: PUREPATH-CMBEVM Hello,
I'm just getting started with the evaluation. I'd like to run 192kHz sample rate signals to test performance over the entire frequency range of the device.
A few questions -
1. I was surprised there is no technical…
Hideaki-san ,
Can we please confirm how they are setting up the cache for L3 and L2. Are they using our CSL code to setup the L2 configuration registers and setting up the MAR bits correctly ? Do we know if they are checking for Cache misses?
For…
Aakash,
There are criterias that ought to be met for those bits to get set or cleared. see attached pdf which you might find helpful. As for FC bit getting set you need to meet primary charge termintionas describe in the technical reference manual of…
Other Parts Discussed in Thread: WL1831 , DA8XX , TPS65217 , WL1271 Dear TI Expert!
I having problem when using Murata WL1831 with Prebuilt Image.
With wifi, I cannot scan the AP, with Bluetooth I cannot power on module by Bluetopia stack, please…
Hello Surender Sharma
Please use the below schematics for implementing the JTAG buffers with JTAG pulls placed near to the SOC JTAG signals
In case wakeup from deep sleep is required refer the below schematic for making updates to FT4232 section.…
Hello User,
Thanks for choosing TI's AFE.
Firstly, make sure 455 is correctly waken up by driving wakeup pin 0-1-0.
Secondly, MCU should issue a complete command frame to 455 otherwise a communication clear should be issues to recover UART engine…
Hi Dpryan,
Figure 29 in the data sheet is more or less an example shown out to 1k when using a 2k modulator clock. We wanted to show the noise shaping out to fmod = fclk/2 and not necessarily the behavior of the converter. We try to explain that with…
I am attaching a couple of documents that should be helpful for obtaining the relevant information.
In particular, Table1 of the attached document (spraca4) offers specific guidelines on ball pad dimensions for a range of BGA dimensions. This
can…
Joe,
I am attaching the TRM of the eval board here. It has the details of 80 pin connector.
Alternately, the same doc is enclosed in the CD which comes along with the eval board.
5516.TMDXEVM6678L_Technical_Reference_Manual_2V00.pdf
Regards
…
Part Number: TPS43060 Other Parts Discussed in Thread: WEBENCH-CIRCUIT-DESIGNER Dear Specialists,
My customer is considering TPS43060 and has a question.
I would be grateful if you could advise.
---
I have a question about the result between WEBENCH…
