Part Number: DP83561-SP Tool/software: Hello, can you support the question below please:
I was reading about that part’s two-supply mode, and the datasheet has the following recommendation in section 9 on page 90:
“In the Two-Supply Configuration…
Part Number: DP83561-SP Tool/software: Hello,
In the specification section 7.3.2.1 the RGMII implementation recommends the DP83TG720 ibis model.
Is this correct? I have the DP83561 model, but the other model appears to be correct as it calls out rgmii…
Part Number: DP83561-SP Tool/software:
Hello,
What is the clock 90 output? It's only refenced in 7.6.1.43 Table 7-54 of the part specification.
There's no definition elsewhere. Also the RGMII skew is selectable only by software, not the straps, correct…
Part Number: DP83561-SP Tool/software: Hello,
For the impedance control, the 35 ohm recommended for RGMII in table 7-59 for MAC_IMPEDANCE_CTRL seems wrong in the specification and does not match the 50 ohm recommendation in 7.3.2 of 50ohms +/-20%.
Is…
Part Number: DP83561-SP Tool/software: Hi team,
Can you help me with this question regarding the memory of the device?
- what memory cells are in the device?
- is there volatile memory and can you expand on that a bit? what is the bit cell technology…
Part Number: DP83561-SP Tool/software: Hi Team,
I am investigating the DP83561, and I noticed there is no max slew rate for the power supplies specified within the datasheet.
Is there a max voltage differential and see if there is any slew rate spec not…
Part Number: DP83561-SP Tool/software:
Hello, in figure 6-1 of the DP83561-SP datasheet, for the power up timing, is T1 with respect to the VDD rail coming up or with respect to clock edge?
We were not certain given the parameter description for T1…
Part Number: DP83561-SP Tool/software: To whom It May Concern,
Hope you're well.
Please allow me to submit inquiry regarding Static Burn-In for device below?
P/N:5962F2021601VXC
Date Code: 2113B
Per SMD, it says "Static Burn-In test shall be performed…
Part Number: DP83561-SP Hi there,
I have a question about the 3-supply power-up for the DP83561. The datasheet shows the preferred method is to power up all supplies at the same time, however, in our case, the +1.1V supply is the first to ramp up, and…
