Part Number: DP83620-EVK Other Parts Discussed in Thread: DP83620 , TIDA-00928 Hello,
I'm working on DP83620-EVK with a 1000BASE-SX SFP Transceiver. But no traffic is observed.
The phy is configured in fiber mode (i.e: FX_EN):
If I set the loopback…
Part Number: DP83620-EVK Other Parts Discussed in Thread: DP83620 , , USB-2-MDIO Hi,
We just bought the DP83620-EVK evaluation board in order to test DP83620.
We need to acces the MDIO link with the USB port as it is indicated on board user manual…
Part Number: DP83620 Other Parts Discussed in Thread: MSP-EXP430F5529LP , USB-2-MDIO Hello TI,
As per the discussion over thread:
I am now trying to connect the DP83620 EVK using the MSP-EXP430F5529LP board however I am unable to do so and the tool…
Part Number: DP83620-EVK Other Parts Discussed in Thread: DP83620 Dear TI Community,
When we boot the DP83620 in 100Base-FX mode we cannot ping the server for an IP address. It works in 100Base-TX mode. Do we need to change the Mii interface or configuration…
Hi Ronnie,
In RMII master mode, RX_CLK will be 25MHz during reset:
I believe both TX_CLK and CLK_OUT would be in a high impedance state (floated). A test on the DP83620 EVK could confirm this. Since DP83620 is an older part with limited support…
Other Parts Discussed in Thread: DP83620 , ALP I just received the above EVK and I am looking for the support software to go with it.
User Guide states -
2.10 Register Access Software
Access to the device registers is available with the use of National…
Hi Ronnie,
DP83822 has similar functionality to DP83620, however these are two separate parts. I cannot guarantee they will treat the CLK pins the same during reset.
For DP83620, RX_CLK will operate at 25MHz in reset:
To confirm the behavior of…
Hello Anees,
Please refer to the below thread for reference
https://e2e.ti.com/support/interface-group/interface/f/interface-forum/1039271/dp83620-evk-dp83620-evk-sfp-transceiver-compatibility
Regards,
Sreenivasa
Hello,
We do not have a dedicated DP83620 Linux driver. However, according to the post below, the generic PHY driver should suffice.
https://e2e.ti.com/support/interface-group/interface/f/interface-forum/300482/dp83620-linux-driver
In regards to…
Part Number: DP83620 Other Parts Discussed in Thread: USB-2-MDIO , EK-TM4C123GXL , MSP430F5529 , ALP , DP83640 Tool/software: Linux Hello,
I am working on the development board for DP83620 and trying to connect the fiber mode.
I have made the necessary…
