Part Number: DP83848I-MAU-EK Hello folks,
I am looking to do test of the 83848 with the DP83848I-MAU-EK/NOP B prototyping board. What I need to do is send data from a bit error rate tester (BERT) through the RJ45, into the phy and then back to the BERT…
Hi Aniruddha, On a previous message I have attached a diagram of where the customer was measuring the eye diagram like you asked and I added some additional information that they shared. I am asking you if you have any information you can share on how…
Part Number: DP83848I-MAU-EK Other Parts Discussed in Thread: USB-2-MDIO Hi,
I am using with MSP430G2 and DP83848 MAU combine . The MAU came with default at 100Mbps. The script in USB2MDIO tool set for 100Mbps. I tried change it to 10M. Not work. I had…
Hi Roy,
Unfortunately, we don't have any Evaluation board for DP83848QSQ package.
We recommend to use the following EVM board (DP83848I) to evaluate DP83848PHY:
https://www.ti.com/tool/DP83848I-MAU-EK
--
Sincerely,
Hillman Lin
Part Number: DP83848J Other Parts Discussed in Thread: DP83848K-MAU-EK , DP83848I-POE-EK Hi Team,
Can you please help addressing below queries.
How to find the IP address for Evaluation kits DP83848K-MAU-EK & DP83848I-POE-EK?
Kindly suggest USB cables…
Hello,
DP83848 MAU EVM has RMII support. Please see more information on the product page for that board.
https://www.ti.com/tool/DP83848I-MAU-EK
Sincerely,
Gerome
Hi Devitt,
Can you please get hold of EVM on ti.com and do the same compliance? This will give us an indication if there is any setup issue which is causing the failure. The EVM design is tested for compliance and we can use this as golden device.
DP83848I…
Part Number: DP83848I Hi,
we have several questions for this device:
1. does it support both straight cable and crossover cable?
2. does the software driver of DP83848I compatible with RT-Thread operating system?
3. what's the difference between DP83848I…
Part Number: DP83848K DP83848K
Hello,
My customer tested the 100 Base-TX, UTP Differential Output Voltage (+Vout/-Vout) with DP83848K-MAU-EK EVM.
But these results ware failed.
(Test result:)
+Vout: Trial 1 (Worst): 1.0670 V, Trial 4: 1.0667 V, Trial…
Hi Gerome,
thank you for suggested EVM. Unfortunately there are all out of stock at this moment. I need at least 3 pairs...
To add information I need following. It must be capable of etherCAT:
The PHYs have to comply with IEEE 802.3 100BaseTX or 100…
