The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Hi Evan,
Thank you for your respense.
I steel have problem, d'ont work for me but I've noticed that to configure the DP83848I-MAU-EK for SNI mode, we need to set the following pins:
RX_DV = High
TXD_3 = High
And also :
AN_EN = Low
AN0 …
Part Number: DP83848I-MAU-EK Other Parts Discussed in Thread: DP83848YB , DP83848I , DP83848C ,
I was going through the part DP83848 (10/100-Mbps Ethernet PHY transceiver) and in the ordering info within datasheet, I found that P/N DP83848YB only differs…
Part Number: DP83848I-POE-EK Other Parts Discussed in Thread: DP83848I , Hi,
I am trying to use DP83848i in SNI mode to communicate with the processor MC68360.
I got the eval board DP83848I-POE-EK for this Ethernet chip (Schematic attached).
Jumper setti…
Part Number: DP83848I-POE-EK Hi Team,
My customer is using DP83848N (Not in Ti.com, while I am trying to reach out you through DP83848I-POE-EK) with PoE. when they plug the network cable, overshoots occur in IC's pins (TD-/TD+/RD-/RD+) as the figure shown…
Part Number: DP83848I-MAU-EK Hello Team,
My customer has a DP83848I-MAU-EK/NOPB being ordered and we see on the schematic there is an ON-MII-MALE interface. Does this product come with the female side to interface? Do you know where they can find a connector…
Hi Muneeswaran,
You are posting on the TI public e2e forum. I don't think Naveen will be notified. However, I may be able to help you. Are you using EK-TM4C1294XL along with another TI product or board? I'm not clear on your question as to the link…
Part Number: DP83848I Other Parts Discussed in Thread: CC2640 Dear TI team,
Thank you for your support.
This is Takashi from Digi-Key.
Can you let us know Giteki (telec) number for DP83848I-MAU-EK/NOPB?
Giteki is Japan RF law.
www.tele.soumu.go.jp…
Part Number: DP83848I-MAU-EK Other Parts Discussed in Thread: DP83848I Hello folks,
I have an DP83848I-MAU-EK/NOPB board from TI. What I need to do is have data going through the phy while I expose the chip to conditions. What I did was put on the 50mhz…
Part Number: DP83848I-MAU-EK Hello folks,
I am looking to do test of the 83848 with the DP83848I-MAU-EK/NOP B prototyping board. What I need to do is send data from a bit error rate tester (BERT) through the RJ45, into the phy and then back to the BERT…
