Part Number: DP83848Q-Q1 Other Parts Discussed in Thread: DP83848-EP Hi Expert:
We are testing DP83848Q-Q1 read PHY identifier register #2 (address 0x03h) = 5c90 , but datasheet show =5Ca2 different with test result.
we check IC top marking is DP83848QSQ…
Part Number: DP83848Q-Q1 Hello Expert:
we have customer design in DP83848Q-Q1 Ethernet PHY transceiver 100-Base-TX design from Automotive Gateway communication with OBD application.
currently MAC Layer cannot read DP83848Q-Q1 address . (MDIO cannot access…
Part Number: DP83TC812R-Q1 Other Parts Discussed in Thread: DP83848Q-Q1 Hi Expert,
Our customer want to use 812R and DP83848Q-Q1 but they only have one MAC. Is it possible? Thanks.
BR,
Elec Cheng
Part Number: DP83848Q-Q1 TI Experts,
in DP83848Q-Q1 - is it possible to have LINK activity feedback in IC register - so SW can read it?
The only way described in the datasheet is LED - it provides physical and visual feedback, but is there a way to hav…
Part Number: DP83848Q-Q1 We currently use the DP83848TSQ and HSQ components for one of our products. We use the two interchangeably, but due to supply chain issues we are looking for other alternate low risk swap in parts. The DP83848QSQX/NOPB matches…
Part Number: DP83848Q-Q1 Hello Texas instruments specialists,
I have some weird behavior with DP83848Q-Q1 which I can not understand. I don't have 50MHz output at Pin "CLK_OUT".
Description: We use the Pin "X1" to input a 50MHz oscillator…
Part Number: DP83848Q-Q1 Hi,
I have a question about TI DP83848QSQ (100base-TX): What is a common duration from enabling it till a link-up is happening?
Regards,
Jon
Part Number: DP83848Q-Q1 Other Parts Discussed in Thread: DP83825I Hi,
I have an application where I need a phy to interface with a Network Controller (NC) which has a NC-SI/RMII sideband. Since both phy and NC have the same orientation for inputs/outputs…
Part Number: DP83848Q-Q1 Other Parts Discussed in Thread: DP83848T , DP83848H Hi, Good day. Our customer has a question about the possible alternate for DP83848QSQ/NOPB. Kindly see below. I am currently using the DP83848QSQ/NOPB ethernet phy chip, but due…
Part Number: DP83848Q-Q1 Hi Team,
There is a good new that we DIN DP83848Q-Q1!
But cause it is out of stock !
Does DP83848LFQ or DP83848H is a good solution to replace?
If yes, is there anything to pay attention to in the design? THX
