Part Number: DP83849ID Tool/software: Hi ,
For my one my ethernet interface design, there is reflections occurred in the RX signals while doing the signal integrity.
Is it recommended to add series termination for the driver side of rx signals and…
Part Number: DP83849ID Hi,
DP83849ID is a dual PHY with 2 dedicated MACs required. Can you suggest some 2-Port Ethernet Switch ICs or Dual PHY with single MAC options available with TI that provides MII/RMII interface?
We are currently evaluating…
Part Number: DP83849ID Other Parts Discussed in Thread: DP83849C , , DP83849I , DP83849IF Hi team,
My customer is using DP83849ID. And they only need the RJ45 port and no need to use fiber port. But now we are facing deliver shortage on DP83849ID…
Part Number: DP83849ID Other Parts Discussed in Thread: DP83869 Hello,
I'm wondering what the receiver input voltage is for 100Base-FX for DP83849ID? I see the transmit voltage of 300 mV to 930mV but don't see anything for the receive input voltage…
Part Number: DP83849ID Dear colleague,
We have a customer asked below questions.
Could you please reply these questions?
1. The difference between "Forces 100Mb/s Good Link" and "Normal 100Mb/s Operation".
2. Without its 16h address register…
Part Number: DP83849ID Other Parts Discussed in Thread: DP83849IF
Hi,
We used DP83849IF before in our solution, but later I wanted to change it to DP83849ID. After the modification, the electrical port can communicate, but the fiber port cannot link…
Part Number: DP83849ID Hello:
I use DP83849ID for ethernet, use mode 0,when I insert the cable,Link Led is Ok,but Active Led always light,the net can not connect ,Please give me some advice,thanks a lot !
Part Number: DP83849ID Other Parts Discussed in Thread: DP83849I , DP83849IF Hi Team,
Can DP83849I support Copper to Fiber convert without host controller (MCU or MPU)?
Customer application is like below,
Thanks & Regards
Eddie
