Part Number: DP83867CS Hi Team,
We are using DP83867CS PHY for our SGMII Interface 10/100Mbps
We are getting MDI Link up.
But we couldn't able to ping the device.
Please find the register dump below.
=> mdio read FM1@DTSEC9 0-0x1f Reading…
Part Number: DP83867CS Tool/software: Hi team,
Could you tell our recommeded pulse trans and RJ45 connectors for DP83867CS?
Regards,
Noriyuki Takahashi
Part Number: DP83867CS Tool/software: We are using the PHY in mirror mode and it works. We did notice after our design was fabricated the following in the data sheet in section 7.4.6.5: " In Mirror mode, the polarity of the signals is also reversed "…
Part Number: DP83867CS Tool/software: Hi TI Team,
We are using DP83867CS in our upcoming project. We are using INTEL I210S for providing SGMII input to the PHY, The ethernet is not working. Can you please guide with the below Queries:
1) Does DP83867CS…
Part Number: DP83867CS I have made a design using Tri mode ethernet MAC IP (TEMAC) with RGMII interface. The problem I am facing is that the data/ethernet packet being sent from the FPGA logic looks fine on Vivado ILA, but that same ethernet packet shows…
Part Number: DP83867CS Other Parts Discussed in Thread: AM625 Tool/software: We are finding that the link status of the DP83867CS is not being read reliably over the MDIO. Our new board, Beagle Violet uses an AM625 host processor running Linux. By default…
Part Number: DP83867CS Tool/software: Hi Sir/ Madam,
I am going to connect two phy chips DP83867CSRGZ and DP83867IRPAP,
Do I have to use a transformer or two transformers that has better performance? If so, do you have a reference design to help our…
Part Number: DP83867CS Tool/software: Hi,
One of my customer is using Ethernet Phy DP83867CSRGZT in SGMII mode, for LTE Program. Please find our block diagram shown here.
They are currently facing as issue in the field nodes, where they have…
Part Number: DP83867CS Tool/software: Hi,
We have a PCB which uses DP83867CS which was working OK for several months, but has developed a fault where a network link is no longer established.
I followed the "DP83867 Troubleshooting Guide", which recommends…
