Part Number: DP83TC818S-Q1 Tool/software: Hello teams ，
The DP83TC818S-Q1 integrates IEEE802.1AS / IEEE1588v2 hardware time stamping & fractional PLL, enabling highly accurate time synchronization.
I think it can support 802.1CB, 802.1CB need to be…
Part Number: DP83TC818S-Q1 I am looking for a Ethernet Mac secure Phy chip and found the datasheet for DP83TC818S-Q1 in the TI webpage but it does not give any pin definition, which pin is ground, power ect. I do not see any information on current requirements…
Part Number: DP83TC818S-Q1 Other Parts Discussed in Thread: AM263P4 , Tool/software: We are considering using a the PHY - DP83TC818S-Q1 with an AM263P4 microprocessor but need to know if the DP83TC818S-Q1 PHY can be configured to use a Preshared Key for…
Part Number: DP83TC818S-Q1 Tool/software: I am looking for an Ethernet Phy chip that has the MAC secure (MACsec) feature, is 10 BASE-T / 100 BASE-T and interfaces with RMII. The part I looked at, DP83TC818S-Q1, is 100 BASE-T1, which is not the same as…
Part Number: DP83TC818S-Q1 Tool/software: Hello,
I found the following register init sequences in the sample code provided ( dp83tc818.zip) which are executed during chip init phase.
DP83TC817_cs1_1_master_init
DP83TC817_cs1_1_slave_init…
Part Number: DP83TC818S-Q1 Other Parts Discussed in Thread: TPS23730 Tool/software: Hi TI,
We are using the DP83TC8 with an RGMII interface in our current design and plan to implement a POE design with the TPS23730. However, we noticed that the IEEE…
Part Number: DP83TC818S-Q1 Tool/software: Hello Expert,
Could we use media clock PHY(818/817) and simple TSN PHY(competitor) on same network? If it is ok, Is there any key consideration for design?
Best regards, Kazuki Kuramochi
Hi Carlos,
The 10BASE-T1L products are generally suitable for 2000+ meters. The 100BASE-T1 products have been tested with cable lengths up to 15 meters. The 1000BASE-T1 products are also generally intended for cable lengths of 15 meters or less but…
Part Number: DP83TC812R-Q1 Hi Team,
can you check if it is possible to replace the DP83TC812R-Q1 by DP83TC818 using 0R resistors for connecting the PINs, which are different to the right signal? To satisfy 2 Costumers with 1 Layout.
Thanks
