Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV3245-Q1 Are DRV8305NQPHPRQ1 and DRV3245AQPHPRQ1 pin compatible ?
If you have difference list between these 2item,please send it to us.
Our customer can't get DRV8305NQPHPRQ1.
Regards,
Ku…
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: TEST Our customer has following questions about DRV8305-Q1 WAKE pin .
1.Regarding the electrical characteristics, the input voltage of WAKE is "Output logic low (high) voltage".
VIL…
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8305 , TEST
Please tell me what difference is between DRV8305NQPHPRQ1 and DRV8305NPHPR.
Our customer can't get DRV8305NQPHPRQ1.
Part Number: DRV8305-Q1 Our customer has a question about the TI pre-driver: DRV83055QPHPRQ1.
On the board equipped with DRV83055QPHPRQ1 created in the past, the current detection accuracy becomes worse as the amount of current increases. The reason is…
Part Number: DRV8305-Q1 Please let us know about PVDD_UVLO2 of DRV8305NQPHPRQ1.
The threshold value of PVDD_UVLO2 is stated as 4.4 to 4.7V on the data sheet.
Is it possible to enter P VDD_UVLO2 even at voltages above 4.7V due to variations of IC? (For…
Hi Kura-san, Allow me to answer some of the newer questions: Q3: I need to look up the deglitch times in our internal database, which each fault should have their own deglitch time for min and max value. I will provide this tomorrow. Q4: PVDD undervoltage…
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: TEST Hi all
My customer is using the DRV8305-Q1 and has below question.
Please review and comment.
Best regards
Ueli
------------------------------------------------
I’m looking to update my mosfet…
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8350 Hi team,
For DRV8305N, if MCU watchdog is not used, can customer just float PWRGD pin? Will this cause any problem to the device since PWRGD pin has pullup to VCC?
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8305 Couple questions on the Wake pin of the DRV8305 that are not addressed in the datasheet (that I can find):
Is there a pull-up or pull-down on the WAKE pin?
What is the timing required after…