Part Number: DRV8353R Other Parts Discussed in Thread: LM5008A I am using the integrated LM5008A buck regulator inside the DRV8353RS.
I would like to clarify a difference between the CCM operating frequency calculated from Equation 2 in the LM5008A…
Part Number: DRV8353RS-EVM Hi,
We ordered DRV8353RS eval kit for our 48V motor control application.
Rated and peak power for our motor is 4kW and 7kW However we want to test our motor in no load condition using eval kit hardware.
Is there any guide…
Part Number: DRV8353R Hi support team.all.
I would like to know the variation values for each of the four thresholds of SEN_LVL.
Could you please provide information on these Min/Max values?
Best regards,
DH
Part Number: DRV8353R Other Parts Discussed in Thread: DRV8353 , DRV8350
Hello,
I'm having issues with DRV8353RSRGZR that has repeatedly required the device to be replaced (~10 chips across 2 prototype boards).
We successfully have used this chip…
Part Number: DRV8353RS-EVM Tool/software: HI all
I am trying to understand how can I achieve forward and reversed direction of motor using this truth table as in refer. manual INHC will decide the motor direction which can be 0 or 1.
I have shared…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8301 We are using the DRV8353RS EVM and the board is not working properly. We have trouble with the gate not switching properly. The gate driving output of the board is at too low of a voltage…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: MOTORWARE , , LAUNCHXL-F280025C , DRV8353 We installed the CCS, the motorware and blackhawk control software and tried to connect and run our motor controller but it did not work. We used the…
Part Number: DRV8353RS-EVM Hi TI team,
I am running into two related issues on a custom board built around the DRV8353RS and would appreciate some guidance before I start changing register settings blind. I have attached plots of bus voltage, bus current…
Part Number: DRV8353R Hi,
Please check our schematic diagram for DRV8353RH, we test the current of the V-phase and it is small than the UW,
the current is about 4/5 of the UW, please advise how to solve this issue, thanks.
mz-2501-drv-30-va01-20260722…
