Part Number: DRV8706S-Q1EVM Other Parts Discussed in Thread: DRV8706H-Q1EVM , MSP430F2617 , MSP-FET We have two boards; DRV8706S-Q1EVM and DRV8706H-Q1EVM, both behave identically and exhibit the same problem.
I have installed the EVM GUI on one PC and…
Part Number: DRV8706S-Q1EVM Other Parts Discussed in Thread: DRV8706-Q1 Hi, I am working with DRV9706S-Q1EVB and a 5V MCU eval board. Trying to get SPI comms working well.
MCU Eval board SPI and GPIO is at 5V logic level. I have removed all the 0R resistors…
Part Number: DRV8706S-Q1EVM Hi Team,
A customer encountered some error while testing the DRV8706S-Q1EVM. Below is his email.
The board has a slightly strange behavior and i hope you can help me to understand what is happens Sometimes when i power…
Hi Jacob,
We have recently acquired the DRV8706S-Q1EVM and we are eager to complete this project with your assistance. We kindly request your guidance and support to ensure a successful outcome without any losses. We appreciate your cooperation and…
Part Number: DRV8706S-Q1EVM ① Regarding “UV” confirmed in the 2nd bit of IC_STAT_1 Register, Is the following understanding of the conditions for UV = 1b correct?
An abnormality is determined when any of the UV values and conditions described in Table…
Hi Ryan,
First of all thank you for your answer. Regarding question 1 here are more details : when you look at a typical h-bridge config, you usually have the transformer as highlighted in Fig1. However when I look at the DRV8706S-Q1EVM schematic(Fig2…
Part Number: DRV8706S-Q1EVM Other Parts Discussed in Thread: DRV8706-Q1
I am using the DRV8706S.
The output is controlled by the PWM signal of the MCU.
A shunt resistor is used to measure the load current.
I want to maintain the Vso value until…
Part Number: DRV8706H-Q1EVM Other Parts Discussed in Thread: DRV8702-Q1EVM Tool/software: The board comes with the J2 block connector for VBAT and a second block connector for PVDD which is supposed to power the H-bridge. I assumed VBAT was dedicated…
