Part Number: DS100BR410 Tool/software: The DS100BR410 supports de-emphasis. Is there any literature to show what the driver's de-emphasis waveform looks like?
Thank you very much.
Regards,
Matt
Hi Matt,
DS100BR410 is a legacy device and we unfortunately do not have the max junction temperature characterized. However, we do have other thermal parameters characterized.
Theta JA-High K: 27.3
Theta JC, top: 11.2
Theta JB: 9.9
Psi JT: 0.1
Psi JB…
Part Number: DS100BR410 Tool/software: Hello, I'm in the process of choosing an Equaliser where I require x5 channels supporting a data rate up to 3.2Gbps. In my initial search this part appeared to be a potential contender, though the datasheet lacked…
Part Number: DS100BR410 Other Parts Discussed in Thread: DS125BR820 Tool/software: reposting this as it hasn't been resolved. I need to replace DS50EV401SQE/NOPB which is EOL. Is the DS100BR410SQE/NOPB a suitable replacement for a PCIe gen2 application…
Hi Lucas,
TKS for your reply. About the issue of p eak-to-peak signal amplitude and the eye height.I have two question:
1 If i need to evaluate the signal@ input pin of DS100BR410.How to evaluate the closed eye diagram whether meet the requirement of DS100BR410…
Part Number: DS100BR410 Tool/software: Good afternoon,
What are the main performance differences between the three PNs listed in the thread title? I see that the 401 and 800 devices each have 8 channels where the 410 only has 4 and I noticed the pinouts…
Part Number: DS100BR410 Tool/software: What is the recommended replacement part for a Gen2 PCIe application? Is it the DS100BR410SQE/NOPB or is there a better choice?
Part Number: DS100BR410 Other Parts Discussed in Thread: DS100BR111 , DS100BR111A
Hello,
I have a on board chip to chip connection with 10G SFI to 10G XFI(no optical modules involved), due to the long trace I would like to use DS100BR410 in the middle…
Part Number: DS100BR410 Tool/software: Good morning,
Is it acceptable to leave the SDA, SDC, and CS pins on the DS100BR410 device not connected when I have the component set to pin control mode? On the datasheet it has a note that says external pull…
Part Number: DS100BR410 Is it possible to read from a DS100BR410 register or registers the state (high or low) for the BST pins-
BST_2 = Pin 37
BST_1 = Pin 14
BST_0 = Pin 23
For example, can the state of these pins be read from the "Status Register for…
