Part Number: DS10CP152 struggling to decide whatthe actual output level for this device is OUT+ / OUT-
data sheet specifies in LVDS output DC specification
VOD Differential Output Voltage min 250 typ 350 max 450 mV
however if i look at the figure…
Part Number: LMH0002 Other Parts Discussed in Thread: DS10CP152 , Hi,
I would like to interface OUT0+- from DS10CP152 (crosspoint switch) to SDI/nSDI input from LMH0002 cable driver, could you please advise how to proceed (capacitor? resistor ? network…
Part Number: LMH0397 Other Parts Discussed in Thread: DS10CP152 , , DS25CP152 Hi,
I would like to interface OUT0+- pins from LMH0397 SDI reckloker to IN0+- from DS10CP152 LVDS crosspoint switch. I am a little bit confused with AC, DC coupling, single-ended…
Part Number: DS10CP152Q-Q1 Other Parts Discussed in Thread: DS10CP152
You need to make sure that DS10CP152q-q1 supports 1.5 Gbps per Chnel.
We tested the 1280 * 720P 30fps image with FPDLINK3 Single Ended in DS10CP152q-q1 and tried to use the output…
Other Parts Discussed in Thread: DS10CP152 Hello,
Cross-talk is output from OUT0 in my prototype board using DS10CP152.
When IN0 is a clock signal,Cross-talk is not output.
Is there something that is considered to be the cause of this cross-talk?
Could…
Part Number: DS10CP154A Other Parts Discussed in Thread: DS10CP152 Hi, Teams!
I want to use DS10CP154A for 2x2 LVDS Crosspoint Switch.
I know you have the DS10CP152 for 2x2 LVDS Crosspoint Switch.
But d ue to procurement issues, I have to use the DS10CP154A…
Other Parts Discussed in Thread: DS10CP152 Hi,
We are considering 2x2 Cross Point Switch for CML.
Frequency:150～460MHz
Would you please provide the information? Could Analog Switch devices be in place of the Cross Point Switch?
Best Regards,
Kato
Other Parts Discussed in Thread: DS90LV001 , DS90CP22 , DS10CP152 Hi,
We have a unit that is driving a 15 inch LVDS display at 1024 x 768 - 4 data pairs and 1 clock pair (24 bit LVDS). Sometimes we want to drive two displays with the same data. The data…
