Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: DS125BR800A Other Parts Discussed in Thread: DS64BR111 , DS80PCI800 Hi Team
We are currently looking uni-directional re-driver with EQ function , and wondering if out driver is CML, but protocol unknown. (Not PCIe or SATA/SAS)
Can we use…
Part Number: DS125BR800A Hi team,
My customer is using our DS125BR800A and would like to consult with you about the schematic review as below figure.
Could you kindly provide the point from you and customer also would like to know whether there is necessary…
Part Number: DS125BR800A Hello,
I am using DS125BR800A and wanted to clarify the VOD spec value. I am controlling VOD using SMBUS registers and the default value is 1.2Vp-p. My question is if this is 1.2Vp-p single ended or differential. 1.2Vp-p single…
Part Number: DS125BR800A Hi team,
My customer is using our SATA/PCIE retimer DS125BR800A but there is no output clock measured at output of retimer.
The operating frequency is @1.6GHZ. The current swing is about 0.85Vp-p (such as the attached waveform…
Part Number: DS125BR800A Hello,
Can you explain what does "Signal detect assert level for active data signal" ?
Is this the minimum voltage required at component inputs for understanding a logical level ? If not, what is this minimum voltage…
Other Parts Discussed in Thread: DS125BR800A Dear,
In the datasheet, there is table7, Mode pin can set different driver characteristics, could you please help explain what the difference between the four different types?
if we set the Mode to 0, it is…
Part Number: DS125BR800A How can the DS125BR800A not enable PCIE, SAS/SATA protocols, only need to output the input differential signal, and can set EQ value?
The current operation is through the I2C configuration register
Part Number: DS125BR800A Hi Team,
The datasheet of DS125BR800A describes input and output of CML signal should be AC coupling required on high-speed I/O.
Is the AC coupling on input or output is mandatory or AC coupling capacitor could be removed?
And…
