Part Number: DS125DF1610
Hi expert,
In my design, DS125DF1610 is being used in the middle of data path, e.g., A----DS125DF1610------B, running at 10Gbps
I was able to control the outputs A, so it can drive electrical idle waveform(both P and N to the…
Part Number: DS125DF1610 Hi expert,
I'm using Adapt-1 mode in my design, CTLE only mode, based on the FOM, DS125DF1610 will go through the default 32 group values(0x40-0x5f), then select a final value to use.
can you tell me how long this Adapt-1…
Part Number: DS125DF1610 Hi expert
Please refer to below for the eye diagram I got from DS125DF1610, I checked several lanes, I found the eye diagram is not in the middle.
1) Is it correct?
2) If something I didn't configure properly, what could be wrong…
Part Number: DS125DF1610 Hi experts,
I'm using DS125DF1610 in my design with a IL like 6dB, I'm trying to use Adapt-1. I got a few questions about CTLE.
Q1:
In page15 of DS125DF1610 datasheet, it mentions that there are 32 default value in reg…
Part Number: DS125DF1610 Hello, TI
I want to configure the DS125DF1610 to achieve both broadcast and switch functions, but after testing, I found that the experimental results were not correct, so I would like to ask some questions.
(1)As a switch:…
Part Number: DS125DF1610 Hi expert,
According to table18 in DS125DF1610 datasheets, when 0x2F[7:4] is 0x7, the target rate supported are 12.5Gbps, 6.25Gbps and 3.125Gbps.
While in page41, the register map, 0x2F, "0x7: 12.5, 6.5 , 3.125 Gbps", I think…
Part Number: DS125DF1610 Other Parts Discussed in Thread: DS125MB203 Hello TI,
Due to limited conditions, I can only observe eye diagram by obtaining eye diagram data. I configured according to the configuration steps in the Ds125df1610 data manual and…
Part Number: DS125DF1610 I am using the DS125DF1610 chip in my design, can you give a programming guide about the DS125DF1610? my My email address is feixiang.li@ebang.com.cn , thank you!
Hi,
Apologies for answering the wrong question, please see the excerpt from the programming guide below. Please set XPNT_EN=1, EQ_BUFFER_EN=11.
Thanks, Drew