Part Number: DS160PR410-Q1
Hi TI Experts:
We encountered the DS160PR410-Q1 damage during the automotive electrostatic contact discharge (connector pin) ±4kV; Two ICs out of one ECU are all damaged.
The impedance to GND of the TX pins (Pin1/2,…
Part Number: DS160PR410-Q1 HI TI experts:
The DS160PR410-Q1 can be confitured with three different ways according to the datasheet, such as Pin mode, I2C controller mode (master), I2C target mode (slave).
If we want to finally confiure DS160PR410…
Part Number: DS160PR410-Q1 Other Parts Discussed in Thread: DS320PR410 HI TI expert:
1) We had tried to use the Sigcon Architect3-WRTE version GUI to connect DS160PR410-Q1 in our own PCB board, but it failed.
We had tried all kinds of attempts according…
Part Number: DS160PR410
Hello Team,
I have a question about Power-On Default Equalization Configuration at I2C Slave Mode.
in documents(DS160PR410 Programming Guide) , default values are listed below.
- default value of reg_03 : 0x80
- default…
Hi Board Designers,
Inputs related to use case for IBIS and IBIS-AMI simulation models
Four different IBIS and AMI models are provided for AM62Ax.
What are the differences between these models? What is each one used for?
For AM62A, two types…
Hi Davor,
The voltage on the EN_SMB pins are all around 0.9V which means the SMBus of eight device are all in Master mode.
Attached is the schematic. Please help review our schematic and give us advice.
SY6Q_RISER_Board_4A_A_v15_20200519_Quanta…
