Part Number: DS16EV5110A How should I handle the unused CML inputs on the DS16EV5110A?
Is it possible to leave the unused CML (TMDS) differential input pairs floating (unconnected)? Does the “–” pin require a pull‑down or pull‑up resistor? If so, what…
Part Number: DS16EV5110A Other Parts Discussed in Thread: TFP401 , DS16EV5110 Tool/software: We use two DS16EV5110A to drive DVI 2560*1600@60Hz with D0~D5 data, however there is no phenomenon on the PC side with 2560*1600@60Hz edid parameter.
1) PC…
Part Number: DS16EV5110A Tool/software: The data sheet gives the CML output Vocm as Vdd-0.3 to Vdd-0.2 and Vo differential swing as 800mV - 1200mV p-p. At 3.3V Vdd, that means measuring single ended Vo could be 3.1V ocm + 0.6V = 3.7V max which is above…
Part Number: DS16EV5110A Tool/software: Hi experts,
I just tried to run the hspice model provided in the link below:
DS16EV5110A: Customer needs IBIS (or some simulation) model - Interface forum - Interface - TI E2E support forums
but the results…
Part Number: DS16EV5110A Other Parts Discussed in Thread: SN65DP159 Hello,
We are using the DS16EV5110A DVI re-driver chip for input and output DVI streams which interface with an FPGA HSSI transceiver block. Since the FPGA transceiver runs at 1V…
Part Number: DS16EV5110A Hi,
I am using the DS16EV5110ASQ/NOPB part in my design i have confusion with datasheet pin no 1 identification,
Kindly provide the Pin no:1 indication in the below landpattern
DS16EV5110ASQ/NOPB
Regards,
Sreeka…
Part Number: DS16EV5110A Hi,
As recommending the input and output differential pair length match in EVM schematic as shown below, kindly provide length matching details and tolerance for both input and output side.
Regards,
Sreekanth
Part Number: DS16EV5110A Hi all,
I am using DS16EV5110ASQ/NOPB part in my project, the DVI output signals requires pullup resistors ( OUTPUT CML, Open collector). kindly provide the solution
Regards,
Sreekanth
