Part Number: DS25CP104A Dear Technical Support Team,
What is the timing of EN_smb?
Question 1: What is the minimum pulse width when used as a Reset signal? Question 2: What is the minimum wait time until SMBus communication becomes available after setting…
Part Number: DS25CP104A Other Parts Discussed in Thread: LMH0324 , LMH0318
Hello,
we want wo use the DS25CP104A switch in an 3G SDI application (multiplexer with 4 inputs / 4 outputs).
The new device/circuit must support following function:
It must be…
Part Number: DS25CP104A Hi Team,
Because customers have quality testing and production line mass production requirements, the LVDS needs to be processed "one-to-many".
At present, the customer uses DS25CP104A to disperse the LVDS signal source…
Part Number: DS90UB925Q-Q1 Other Parts Discussed in Thread: DS25CP104A Hi Team,
Because customers have quality testing and production line mass production requirements, the LVDS needs to be processed "one-to-many".
At present, the customer uses…
Part Number: DS25CP102Q-Q1 Other Parts Discussed in Thread: DS25CP104A Tool/software: the IBIS-AMI model of the DS25CP104A doesn't work (see the error report below).
The IBIS model cannot load the AMI library. ADS Keysight 2024 update 2 is using for…
Hi Diego,
Unfortunately I could not locate numerical data for DS25CP102 EQ. If you are unable to get the correct pin definitions for DS25CP102, you could try DS25CP104A IBIS-AMI model. I would expect similar behavior between this and DS25CP102.
Please…
Part Number: DS25CP104A In the DS25CP104A IBIS model, is there a way to turn on the EQUALIZER to configure for LOW, MEDIUM or HIGH gain? The EQ gain settings are programmed through the SMbus so I am wondering how to do this in IBIS simulation. Thanks…
Part Number: DS25CP104A What criteria does the the Loss-of-Signal circuitry use when determining presence of a valid SDI signal?
The LOS register section states:
"The LOS register reports an open inputs fault condition for each of the inputs. The following…
Part Number: DS25CP104A Hi Team,
Could you please help tell how to simulate the eq/pre-amphasis in IBIS? Is there any document about the usage of the IBIS model? Thanks!
Best Regards!
Hao
Part Number: DS25CP104A Hello team,
My customer would like to know if DS25CP104A can be used same way when positive and negative input are swapped. He is planning to build system with common PCB pattern for both TX and RX. It makes positive and negative…
