Part Number: DS26C31T Tool/software: Dear Team, I have a question about soldering duration. For the DS26C31TM/NOPB, the data sheet states "Absolute maximum rating" for Lead Temperature Soldering, 4s and 260degC. On the other hand, there is also…
Part Number: DS26C31T Hello,
I'm calculating the allowable maximum power dissipation of DS26C31T but I'm not able to find the junction temperature of the IC. In the datasheet storage temperature is given. Can you please explain me the difference between…
Part Number: DS26C31T Other Parts Discussed in Thread: STRIKE Hello,
I use the DS26C31TM driver and the MAX3095ESE receiver. Both are powered by 5V.
I have a resistor network at the receiver input (1K + 100 + 1K), as recommended by the datasheet.
In between…
Part Number: DS26C31T Hi team,
I am using DS26C31TM. I'd like to calculate the power consumption of the terminating resistor under the worst conditions. So could you give me the max of VOH and min of VOL of this driver. Each data sheet only listed up…
Part Number: DS26C31T Hello Team,
can you provide the following thermal resistances, please:
- Junction-to-ambient
- Junction-to-case (top)
- Junction-to-board
Thanks and Best Regards,
Hans
Part Number: DS26C31T Hello,
My customer has been using DS26C31T. The resistance between #2/#3 and GND is around 1.8MOhm when there is no power, but some ICs have a few kOhm or even a few Ohm after working for some time. It works well even though the…
Part Number: DS26C31T Hi sir,
Do DS26C31T and DS26LV32AT have output short circuit protection?
If not have, what protection do you propose to put at the output in order to prevent damage to the component at short to the GND at the output?
also, not interfering…
Part Number: DS26C31T Hi team, Our customer is requesting for the ESD rating for DS26C31T. Also, regarding mil standards. is mil standards 883C the same as 883J? Please let me know if your information to share with the customer for this request. Thanks, Jona…
Part Number: DS26C31T Dear Sirs
I am looking for a spice model for DS26C31TM. could ypu please help me?
By the way I got the IBIS model but I see no Power Clamp table (corrent=0 for every voltage) for output buffer. That means no parasitic diode toward…
