Part Number: DS90CR286A Is there a PSpice model for this device? I checked the product page and it didn't seem to have one. It did advertise the PSpice for TI software, so I thought it might have been included in that package, but I couldn't find it there…
Part Number: DS90CR286A Other Parts Discussed in Thread: DS90CR216A
Hello forum members, I was hoping to use this chip as a straight 1:7 receiver on each channel, but the input to output mapping doesn't seem to match up in the way I expected. I would…
Part Number: DS90CR286A-Q1 Other Parts Discussed in Thread: DS90CF384A , SN65LVDS822 Hi Team,
Because DS90CR286AQMT & DS90CF384A out of stock
RD is looking for other replacement
>>Please help suggest IC
SPEC:
The current image source output…
Part Number: DS90CR286A Other Parts Discussed in Thread: DS92LV2412 , DS92LV0411 Hi Team,
A customer use NXP imx6 to output LVDS signal to drive TFT Display which is 480*272 @60Hz RGB interface. And they want to use DS90CR286A to convert. But the PCLK…
Part Number: DS90CR286A Other Parts Discussed in Thread: DS90CR288A , , DS90CR285 Hello,
My customer has a question about DS90CR286A and DS90CR288A.
Please Could you tell me RSKM value at f=56MHz.
Or could you tell me which dominance is DS90CR286A…
Part Number: DS90CR286A-Q1 Hi team,
customer would like use DS90CR286A-Q1 to drive a 1.8'' TFT, below is TFT spec.
but the min PCLK of DS90CR286A-Q1 is 20MHz, which is higher than TFT clock. do you have other recommendations for this application with…
Part Number: DS90CR286A Hi team,
I have questions about switching characteristics of RxOUT.
1) Customer is using CLK = 27MHz for RxCLK IN. Is there any reference data available for RSRC and RHRC at CLK = 27MHz?
2) As I looked below thread, I think…
Part Number: DS90CR286A Hi Team,
Customer is using DS90CR286AMTD to convert camera_link to RGB, and finds that the RGB receiver can not detect the correct resolution.
The input signal of camera_link camera is 640*512 and the frame rate is 50fps. …
Part Number: DS90CR286A Hi
I have a question about treatments of unused pin "RxIN3+/-".
Should I connect a pull-down register?
Do you have recommendation value?
thanks,