Part Number: DS90UB638-Q1 Other Parts Discussed in Thread: DS90UB635-Q1 , Tool/software: We are still pursuing safety certification for a system using the DS90UB638-Q1 and a DS90UB635-Q1.
It would be very helpful to have additional information on the maximum…
Part Number: DS90UB638-Q1 Tool/software: Hello TI experts,
We meet an issue,
After setting FPD-Link III Parity Checker Enable, the image is stuck.
Can you give us some suggestions?
Best Regards,
Songqing Lin
Hello,
Lee Victor said: We want change to OmniVision OV490, now we need to know how to setting registers,Thank you so much.
Please reach out to the image sensor provider for sensor configuration.
I would like to confirm your imager settings. Please correct…
Part Number: DS90UB638-Q1
We are going through an FMEA (Failure Mode & Effects Analysis) on our system that implements the DS90UB638-Q1.
Of particular concern deep in this analysis is the backchannel output of the RIn0+ pin.
Can you share any details…
Part Number: DS90UB638-Q1 Other Parts Discussed in Thread: DS90UB954-Q1 Hi ,
Can we replace a DS90UB954-Q1 by a DS90UB638-Q1, if we don't need to use RIN1+& RIN1- pins?
regards
Part Number: DS90UB638-Q1 Other Parts Discussed in Thread: DS90UB635-Q1 , I have a DS90UB638-Q1 / DS90UB635-Q1 system running.
I would like to test at a lower forward frequency.
Table 7-8 (Clocking Modes) of the 635 data sheet describes a Synchronous (Half…
Part Number: DS90UB638-Q1 When my link from the DS90UB635 is connected and running BIST I read registers 0x04 (DEVICE_STS) and 0x4D (RX_PORT_STS1) I can see the PASS, LOCK, PORT_PASS, and LOCK_STS bits are all set to 1.
When I probe pins 47 (PASS) and…
Part Number: DS90UB638-Q1 Hello
where can i find the requements for FPDlink III ? my goal is to characterize the pcb Trace . for that i wish to know the mini allowed inertion loss and as well as allowed return loss.
Could you provide me the link or doc…
Part Number: DS90UB638-Q1 Other Parts Discussed in Thread: DS90UB954-Q1 , ALP , USB2ANY We replaced the DS90UB954-Q1, on one of our EVMs, with a DS90UB638. I connected it to the DS90UB953 serializer EVM and the lock and pass LEDs come on. It seems to be working…
