Part Number: DS90UB913Q-Q1 Hello
I am using a PCLK from my camera module to DS90UB913Q, On camera module the pclk is good but at the output Deserializer is noisy when the camera module is darken.
When I light the Image sensor the pclk is ok at the De…
Part Number: DS90UB913Q-Q1
Hello
In our design, DS90UB913Q & 914 we are working in default mode ,the ISC are set in passthrough mode but we don't see the ISC on DSUB913 side, only on DS90UB914.
The DATA, HSYNC,VSYNC,PCLK is transmit ok.
Attached…
Part Number: DS90UB913Q-Q1 Hello
Regarding DS90UB913Q-Q1 unused pin like: GPO_1,GPO2, GPO3,DIN10,DIN11 can be floating?
DS90UB914QSQ unused pin like: Rout10, Rout11, can be floating?
Roi
Vincent,
thanks for sharing these details.
Vincent Jonas said: it is a high quality CAT 7 cable with a length of 30m.
This length of cables we usually do not support. You must have a very good design + the low data rate to be able to support this cable…
Part Number: DS90UB913Q-Q1 Our application only needs to transmit audio I2S, and the distance is 20 meter.
I found DS90UB913A can be reached to 25 meter.
But it looks like for camera interface, is it suitable for transferring I2S data?
If yes, how many…
Part Number: DS90UB914A-Q1 Other Parts Discussed in Thread: DS90UB913Q-Q1 , Hi,
Having problems using the DS90UB913Q-Q1 for transmission and using the DS90UB914A-Q1 receiver with STP and 25-100 MHz PCLK?
Thanks
Part Number: DS90UB913Q-Q1 Hi Team,
I see on the datasheet that the device is recommended for 15m cable length.
Do we have other devices that have more reach?
Is there method to accomplish this? (potentially cascading multiple SerDes devices to extend…
Part Number: DS90UB913Q-Q1 Dear Sir,
My system based on DS90UB954, it can find DS90UB953 baord and operate correctly, but it cannot find 90UB913 board anyway.
Can you give me more advice?
Best regards.
David
Part Number: DS90UB913Q-Q1 Hi, Is it possible to use SerDes for sending only parallel GPIO (let say 7 bit data) over coax/STP cable in vehicle? Since I'm not sending video, is it possible to eliminate Hsync/Vsync signals? Or it's mandatory for the protocol…
