Part Number: DS90UB934-Q1 Tool/software: Hello，
When using DS90UB934-Q1, the frequency is 456.23MHz, which emits a lot of radiation and affects the surrounding circuits. DS90UB934-Q1 outputs DVP to MS1824, PCLK clock is a 76MHz accessory, which happens…
Part Number: DS90UB934-Q1 Tool/software: Dear sir
Confirm the following SPEC:
① Is there a maximum value for FPD-Link III Receiver VID and VIN? Do the measured waveforms meet the specifications?Please refer to the attached file for the measurement…
Part Number: DS90UB934-Q1 Dear sir
As shown in the figure below: DA is the DES (934A) used by our company, APS is the SER on the competitor's side.
QA:
1. What are the registers related to LVDS locking? 2. Are the registers set to enable the BackChannel…
Part Number: DS90UB934-Q1 Tool/software: Hi team,
My customer will use 934/914 deserializer for LVDS to DVP output. Need to confirm which serializer part number able to be the correct selection in serializer side?
May I know if all of the below serializer…
Part Number: DS90UB934-Q1 Tool/software: Hi Team,
Please help with the following questions.
Thanks.
1. The connection between UB933 and UB934 has failed; both the PASS and LOCK are low. What point can I check with the issue?
2. How to set…
Part Number: DS90UB934-Q1 Tool/software: Hi team
Thanks for your previous supporting on E2E.
We have a small question, could you please help comment:
The slew rate of VDDIO and VDD18 should be more than 1ms in the datasheet, but the other TI serdes…
Part Number: DS90UB934-Q1 Tool/software: Hello experts,
Datasheet specifies recommended suggested strap resistor values as shown below. As customer concerns resistor value variation due to condensation, they would like to use smaller resistor value…
Part Number: DS90UB934-Q1 Tool/software: Hello experts,
Could you please provide tolerance of 100ohm impedance in STP configuration? I could find a tolerance in coax configuration but could not find the recommendation in STP.
Thanks,
Kento
