Part Number: DS90UB935-Q1 Tool/software: Hi TI team,
I’m working with the DS90UB935 and DS90UB953 serializers and would like to clarify the output current capability of GPIO0~3.
Specifically, I’m planning to use one of the GPIOs to control a reset…
Part Number: DS90UB935-Q1 Tool/software: Since the I2C of the image sensor is powered by 3.3V, the I2C of the DS90UB935 is powered by 1.8V. How can the I2C connection between two chips be achieved? If needed, I can provide the schematic diagram. Please…
Part Number: DS90UB964-Q1 Other Parts Discussed in Thread: DS90UB935-Q1 Dear TI expert: I was debugging a camera link with DS90UB935-Q1 and DS90UB964-Q1. After configuring the i2c configuration of the Serdes link on DS90UB964-Q1, the i2c did not work…
Part Number: DS90UB935-Q1 Hi,
I have a question about the forward data rate of UB935.
In this table, does it mean the forward data rate is controlled by the referenced clock in sync mode?
So the range is from 23x160=3680 to 26x160=4160 Mbps. …
Part Number: DS90UB964-Q1 Other Parts Discussed in Thread: DS90UB935-Q1 Dear TI expert: I was debugging a camera link with DS90UB935-Q1 and DS90UB964-Q1. After configuring the i2c configuration of the Serdes link on DS90UB964-Q1, the i2c did not work…
Part Number: DS90UB935-Q1 Tool/software: Dears,
Could you please provide the register configuration of DS90UB935 serializer to customers? My customer Tianzhun will use it in the domain control project. Please provide it.
Many thanks! Arabella
Part Number: DS90UB935-Q1 Hi E2E,
We try to obtain the corresponding address data, but found that the address values read out did not match the actual ones. For example:
The Sensor is 36 and the DS90UB935 is 18.
But We get 38 and 1C.
Why did…
Part Number: DS90UB935-Q1 Hi TI colleague,
We used ub935 internal always on clock mode(AON mode),the RE testing excessive.
The excessive frequencies are concentrated at 5260/5300 Hz.
How can we optimize through register configuration or hardware…
Part Number: DS90UB935-Q1 would you have an overview of where FEC forward error correction is available, please?
Also which section of the datasheet I can refer to enable / disable / configure this information?
Can you please provide the same…
Part Number: DS90UB935-Q1 Tool/software:
Kindly help here to review the below attached schematic pdf of serializer part (DS90U DS90UB935-Q1 Ser.pdf B935-Q1 ) from TI and please provide your valuable feedback on the same
