Search tips
Showing 258 results View by: Thread Post Sort by

  • RE: DS90UB940-Q1: DS90UB940+DS90UB927 application

    Kailyn Chen said: In the pattern configuration mentioned above, if the total horizontal line width is changed from 1360 to 1350, the image cannot be captured correctly; so adjust the timing of the actual image, HBP = 32,HT = 1360, Hspw=32, VBP = 32, VT…
    • Answered

  • DS90UB940-Q1: LP11 mode

    Resolved
    Part Number: DS90UB940-Q1 Hi team, Could you please tell me how to put 940 into LP11 mode? BRs Haury
    • Resolved

  • DS90UB940-Q1: Register setting to use with DS90UB925 and output CSI2 YUV422 signal

    TI Thinks Resolved
    Part Number: DS90UB940-Q1 What are the required register settings for ub940 when used with DS90UB925 and output CSI2 YUV422 signal? Are there any other caveats when using ub940 with ub925? What if the PCLK is lower than 25 MHz?
    • Answered

  • DS90UB940-Q1: video data status

    Resolved
    Part Number: DS90UB940-Q1 Dear expert, is there any register inside ub940 can show video resolution information received from un941?
    • Resolved

  • DS90UB925Q-Q1: Use Ds90ub940 instead of ds90ub926 with ub925

    Part Number: DS90UB925Q-Q1 We need to deserialize signal from a oem device with ub925 to output csi2 signal. Our ideal choice should be ub940. However, the oem device was designed used with ub926 with device address 0x6A, while the device address 0x6A…
    • Answered

  • DS90UB940-Q1: I2S latency from video data.

    Resolved
    Part Number: DS90UB940-Q1 Hello team, My customer is reviewing 949 and 940. They plan to use I2S for audio implementation. but I don't see information in datasheet about audio latency from video. Could you pls help answer this to customer?? Thank…
    • Resolved

  • DS90UB940-Q1: 949-940 cross FPD-Link III port

    TI Thinks Resolved
    Part Number: DS90UB940-Q1 Hi team, Could we cross the FPD ports between 949 and 940? If it could work, how to configure it? BRs, Haury

  • DS90UB940-Q1: Can DS90UB940-Q1 be connected to two DS90UB925Q at the same time?

    TI Thinks Resolved
    Part Number: DS90UB940-Q1 According to the datasheet, it seems that only the primary input pins can be used when set to backward compatible mode to work with DS90UB925Q. Just want to double check if it's the case. Thank you.

  • DS90UB940-Q1: Can it be used with DS90UB921?

    TI Thinks Resolved
    Part Number: DS90UB940-Q1 It did not specifically mention in the data sheet. However, in table 101 it's listed. If it's supported, are there any specific register bit settings?

  • DS90UB940-Q1: registers & CSI?

    TI Thinks Resolved
    Part Number: DS90UB940-Q1 HI TEAMS: 1. The customer debugged the ds90ub940, which is only used for video conversion. I2C has been passed. Would you like to ask which registers can be read to confirm that the work is normal? 2. If no video signal is input…

Didn't find what you are looking for? Post a new question.